DeWalt A20832, GX390 Danger Risk To Breathing Asphyxiation Continued, English, What Can Happen

Page 5
DANGER: RISK TO BREATHING (ASPHYXIATION) CONTINUED

DANGER: RISK OF FLUID INJECTION AND LACERATIONDANGER: RISK TO BREATHING (ASPHYXIATION) CONTINUED

• Some cleaning fluids

• Use only cleaning fluids

contain substances which

 

specifically recommended

could cause injury to skin,

 

for high-pressure washers.

eyes or lungs.

 

Follow manufacturers

 

 

recommendations. Do not

 

 

use chlorine bleach or any

 

 

other corrosive compound.

 

 

 

 

 

 

Manual backgroundDANGER: RISK OF FLUID INJECTION AND LACERATION

Direct spray away from self

 

and others.

Make sure hose and fittings

 

are tightened and in good

 

condition. Never hold onto

 

the hose or fittings during

 

operation.

Do not allow hose to contact

 

muffler.

Never attach or remove wand

 

or hose fittings while system

 

is pressurized.

• When using replacement

English

WHAT CAN HAPPEN

Your pressure washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh, which could result in amputation or other serious injury. Leaks caused by loose fittings or worn or damaged hoses can result in injection injuries.

DO NOT TREAT FLUID INJECTION AS

A SIMPLE CUT! See a physician immediately!

HOW TO PREVENT IT

Inspect the high-pressure hose regularly. Replace the hose immediately if it is damaged, worn, has melted from contacting the engine, or shows any signs of cracks, bubbles, pinholes, or other leakage. Never grasp a high-pressure hose that

is leaking or damaged.

Never touch, grasp or attempt to cover a pinhole or similar water leak on the high- pressure hose. The stream of water IS under high pressure and WILL penetrate skin.

Never place hands in front of nozzle.

Injuries can result if system pressure is not reduced before attempting maintenance or disassembly.

 

lances or guns with this

 

pressure washer, DO NOT

 

use a lance and/or lance/gun

 

combination that is shorter

 

in length than what was

 

provided with this pressure

 

washer as measured from

 

the nozzle end of the lance

 

to the gun trigger.

To relieve system pressure,

 

shut off engine, turn off water

 

supply and pull gun trigger

 

until water stops flowing.

Use only accessories rated

 

equal to or higher than the

 

rating of the pressure washer.

5

Image 5
Contents If you have questions or comments, contact us GUIDE DUTILISATION MANUAL DE INSTRUCCIONESPour toute question ou tout commentaire, nous contacter Si tiene dudas o comentarios, contáctenosEnglish WEIGHTEngine Pump SpecificationsImportant Safety Instructions Definitions Safety GuidelinesSAVE THESE INSTRUCTIONS 1-800-4-DEWALTEnglish HOW TO PREVENT ITDANGER RISK OF EXPLOSION OR FIRE WHAT CAN HAPPENDANGER RISK OF FLUID INJECTION AND LACERATION DANGER RISK TO BREATHING ASPHYXIATION CONTINUEDDANGER RISK OF UNSAFE OPERATION DANGER RISK OF INJURY FROM SPRAYDANGER RISK OF INJURY OR PROPERTY DAMAGE WHEN TRANSPORTING OR STORING WARNING RISK OF CHEMICAL BURN WARNING RISK OF BURSTINGWARNING RISK OF HOT SURFACES SAVE THESE INSTRUCTIONS FOR FUTURE USE INSTALLATION Pressure Washer Assembly FigWARNING RISK OF ELECTRICAL SHOCK WARNING RISK OF INJURY FROM LIFTINGSpray Wand Nozzles Fig OPERATION Pressure AdjustmentsCHANGING NOZZLES ON SPRAY WAND Chemicals and Cleaning Solventsuse. Do not use bleach TO APPLY CHEMICALS AND SOLVENTSStarting START-UP PROCEDURErefer to Chemicals and Cleaning MAINTENANCEShutting Down SolventsNozzle Cleaning To Clean the Water Inlet FilterHOW TO CHANGE PumpTo Remove Tires ACCESSORIESSTORAGE Engine Pressure WasherLimited Warranty SERVICE INFORMATIONRepairs Date and Place of PurchaseProblem Troubleshooting GuideGlossary CodePOSSIBLE SOLUTION Troubleshooting CodesCODE POSSIBLE CAUSETroubleshooting Codes cont Moteur FrançaisCaractéristiques techniques de la pompe LAVEUSE HAUTE PRESSION, MODÈLE DP3900Définitions lignes directrices en matière de sécurité Fiche techniqueDirectives de sécurité importantes et des conditions de fonctionnement et d’autres variablesDANGER RISQUE D’EXPLOSION OU D’INCENDIE CONSERVER CES DIRECTIVESCE QUI PEUT SE PRODUIRE COMMENT L’ÉVITERDANGER RISQUE D’ASPHYXIE SUITE DANGER RISQUE D’INJECTION ET DE LACÉRATIONDANGER RISQUE D’UTILISATION DANGEREUSE DANGER RISQUE DE BLESSURE PAR JETSuivre la procédure de AVERTISSEMENT RISQUE D’ÉCLATEMENT FrançaisAVERTISSEMENT ATTENTION SURFACES CHAUDES AVERTISSEMENT RISQUE DE BRÛLURE CHIMIQUECONSERVER CES DIRECTIVES POUR UN USAGE ULTÉRIEUR INSTALLATION Assemblage de la laveuse haute pression FigAVERTISSEMENT RISQUE DECHOC ÉLECTRIQUE AVERTISSEMENT RISQUE DE BLESSURE EN SOULEVANT LE PRODUITFONCTIONNEMENT Réglages de la pression CHANGEMENT DES BUSES SUR LE TUBE DE PULVÉRISATION Buses du tube de pulvérisation FigAPPLICATION DE PRODUITS CHIMIQUES ET SOLVANTS Produits chimiques et solvants de nettoyageDémarrage de nettoyage PROCÉDURE DE DÉMARRAGEsection Produits chimiques et solvants Mise à l’arrêt de l’appareil ENTRETIENNettoyage du filtre de l’admission d’eau PompeNettoyage des buses VÉRIFICATION DU NIVEAU D’HUILELaveuse haute pression Retrait des pneuRANGEMENT Moteur INFORMATION SUR LES RÉPARATIONS ACCESSOIRESRéparations Garantie limitéeTube de pulvérisation à branchement rapide ce système permet GlossaireGuide de dépannage SOLUTION PROBABLECodes de dépannage ProblèmeConsulter la section Buses du tube de pulvérisation sous Codes de dépannage suiteS’assurer que l’extrémité du tuyau pour produit chimique soit entière Especificaciones de la bomba MotorEspañol LAVADORA A PRESIÓN CON MOTOR A DP3900Definiciones Normas de seguridad EspecificacionesInstrucciones de seguridad importantes MODELOPELIGRO RIESGO DE EXPLOSIÓN O INCENDIO CONSERVE ESTAS INSTRUCCIONES¿QUÉ PUEDE SUCEDER? CÓMO EVITARLOPELIGRO RIESGO RESPIRATORIO ASFIXIA PELIGRO RIESGO DE INYECCIÓN DE LÍQUIDO Y LACERACIÓN PELIGRO RIESGO DE INYECCIÓN DE LÍQUIDO Y LACERACIÓN CONTINUARPELIGRO RIESGO DE LESIÓN POR PULVERIZACIÓN PELIGRO RIESGO DE OPERACIÓN INSEGURAAL TRANSPORTAR O ALMACENAR LA UNIDAD PELIGRO RIESGO DE LESIÓN O DAÑO A LA PROPIEDADADVERTENCIA RIESGO DE QUEMADURA QUÍMICA ADVERTENCIA RIESGO DE DE ESTALLIDOADVERTENCIA RIESGO DE SUPERFICIES CALIENTES CONSERVE ESTAS INSTRUCCIONES PARA FUTURAS CONSULTAS INSTALACIÓN Ensamblado de la lavadora a presión FigADVERTENCIA RIESGO DE DESCARGA ELÉCTRICA ADVERTENCIA RIESGO DE LESIÓN POR LEVANTAR MUCHO PESOOPERACIÓN Ajustes a la presión Color de la Boquillas para la varilla pulverizadora FigPatrón de UsosPARA APLICAR PRODUCTOS QUÍMICOS Y SOLVENTES Productos químicos y solventes de limpiezaPuesta en marcha PROCEDIMIENTO DE PUESTA EN MARCHA 2. Apague el motor. Consulte el manual de instrucciones del motor ApagadoMANTENIMIENTO Limpieza de las boquillas BombaPara limpiar el filtro de entrada de agua PARA CONTROLAR EL ACEITELavadora a presión Para quitar los neumáticosALMACENAMIENTO Motor INFORMACIÓN DE MANTENIMIENTO ACCESORIOSReparaciones Póliza de GarantíaEXCEPCIONES Garantía limitadaProductos químicos y solventes de limpieza GlosarioCódigos de detección de problemas Guía de detección de problemasProblema CódigoConsulte la sección Boquillas para la varilla pulverizadora en Códigos de detección de problemas continuar CÓDIGO CAUSA POSIBLE 701 Joppa Road, Baltimore, MD D EWALT Industrial Tool CoNOV06 Form No. A20832