Dayton Operating Instructions and Parts Manual
Models 2ZRP8, 2ZRP9
Troubleshooting Chart
Symptom | Possible Cause(s) | Corrective Action |
E
Engine will not start | Engine switch is off. |
| Fuel Tank empty. |
| Fuel Valve is off. |
| Inadequate engine oil. |
Turn engine switch to the ON position.
Fill tank per instructions in this manual.
Turn Fuel Valve on.
Check oil level. This engine is equipped with a low oil sensor. The engine cannot be started unless the oil level is above the prescribed lower limit.
N G L I S H
No spark at spark plug.
Generator has no output. | Circuit breakers tripped. |
| Inadequate cord sets or extension cords. |
Remove the spark plug cap. Clean any dirt from around the plug base, then remove the spark plug. Install the spark plug in the plug cap. Turn the engine switch on.
Grounding the electrode to any engine ground, pull the recoil starter to see if sparks jump across the gap. If there is no spark, replace the plug.
Reinstall the plug and start engine according to instructions in this manual.
Consult Customer Service.
Reset circuit breakers.
Check cord sets or extension cords capabilities in section Controls; Cable Size in this manual.
Consult Dayton Customer Service.
11