Evaporative Emission Components, Engine

Dayton Operating Instructions and Parts Manual

2ZRP8, 2ZRP9

Dayton® Generator

hear or feel a distinctive “click”. IF

ETHE GFCI FAILS TO RESET PROPERLY,

NDO NOT USE EITHER OUTLET OF THE

G DUPLEX RECEPTACLE. Have the unit

Lserviced by an authorized Dayton

ICustomer Service Representative

Simmediately.

H3.High vibration or severe mechanical shock loads may cause the GFCIs to trip. IF EITHER GFCI TRIPS BY ITSELF AT ANY TIME, reset it and perform test procedures 1 and 2.

4.Repeat steps 1-3 for the second GFCI.

ALTHOUGH THE ABOVE TEST

PROCEDURES WILL INDICATE PROPER GFCI OPERATION ON AN UNGROUNDED OR IMPROPERLY GROUNDED GENERATOR, THE GENERATOR MUST

STILL BE GROUNDED PER THE

GROUNDING INSTRUCTIONS LISTED ON PAGE 14 FOR THE GFCI TO FUNCTION PROPERLY AND PROTECT THE USER FROM ELECTRICAL FAULTS.

EVAPORATIVE EMISSION COMPONENTS:

The unit you have purchased includes the following components that are in compliance with 2008 California Air Resources Board Evaporative Emission Standards;

1.Fuel Hose

2.Fuel Hose Fittings

These components should be inspected on a daily basis for cracks, leaks, and abnormal wear. If cracking, leaks or abnormal wear has occurred, the components should be replaced immediately.

IDLE CONTROL ADJUSTMENT:

NOTE: The automatic idle speed is set between 2640 and 2940 RPM.

The idle speed has been pre-set at the factory and should rarely require readjustment. We recommend that all adjustments of this nature be made by a Dayton Customer Service Representative.

Erratic idle operation of the engine usually indicates a need for carburetor adjustment to provide a smooth idle. The idle control will not function properly when the idle speed is below the recommended limits or the carburetor is improperly adjusted.

ENGINE:

The engine for this generator is

Maintenance Chart

Procedure		Every	Every	Every	Before
Procedure	Daily	25 hrs.	100 hrs.	200 hrs.	Storage
	Daily	25 hrs.	100 hrs.	200 hrs.	Storage
Check Fuel	X
Check Engine Oil	X
Check for loose or lost nuts and bolts	X
Check for leaks	X
Check cylinder and head fins for
dust and dirt	X
Check battery electrolyte level	X
Check fuel lines (replace if necessary)	X
Clean air cleaner foam element (**)		X
Tighten nuts and bolts (*)			X
Change engine oil			X
Clean fuel filter			X
Replace air cleaner paper element			X
Clean dust and dirt from cylinder and			X
cylinder head fins (**)			X
Clean and regap spark plug				X
Add fuel stabilizer					X
Run unit dry					X

*Perform these operations after the first 5 hours of use, then at the recommended intervals.

**Service more frequently under dusty conditions.

NOTE: These items must be performed with the proper tools. See your Dayton Customer Service Representative for service, unless you have the proper equipment and mechanical proficiency.