Emerson PMC-CGM manual Not yet supported

MIB DescriptioncgmControl

Table 5-4 cgmBitsTable (continued)

OID	MIB Object	Description	Access
.1.1.2.1.6	dsx1LoopbackConfig	Loopback mode	r/w
		Loopback mode disabled (1)
		local (payload) loopback - Tx to Rx (2)
		line loopback - Rx to Tx (3)
		Default value is disabled (1).
.1.1.2.1.7	dsx1LineStatus	Current line status. This is a bit mask encoding the	r
		following states:
		-Bit 0 (value 0x01): Yellow alarm condition
		-Bit 3 (value 0x08): Alarm condition
		-Bit 5 (value 0x20): Loss of Frame condition
		-Bit 6 (value 0x40): Loss of Signal condition
.1.1.2.1.10	bitsCurSsm	The last received synchronization status message	r
		Not yet supported
.1.1.2.1.11	bitsSsmE1SaSelect	Selects on which Sa bit the E1 synchronization	r/w
		status message is expected.
		Default value is (4).
		Not yet supported
.1.1.2.1.13	bitsLiuJaEn	Enable jitter attenuator	r/w
		Default value is disabled (0).
.1.1.2.1.14	bitsLiuJaDs	Jitter attenuator depth (32 or 128 bits)	r/w
		Default value is 128 bits (0).
.1.1.2.1.16	bitsLiuEgl	Receive equalizer gain limit for T1 (-36/-15dB) and	r/w
		E1 (-43/-12dB)
		Default value is (0).
.1.1.2.1.18	bitsLiuE1Lbo	E1 line build-out select in Ohm (without and with	r/w
		high return loss)
		120 Ohm (1)
		120 Ohm with high return loss (3)
		Default value is (1).
.1.1.2.1.19	bitsLiuT1Lbo	T1 line build-out select for DSX-1 application in	r/w
		feet.
		0 to 133 ft (0)
		133 to 266 (1)
		266 to 399 (2)
		399 to 533 (3)
		533 to 655 (4)
		Default value is (0).

50 PMC-CGM Installation and Use (6806800D53C)