Emerson PMC-CGM manual CgmControl Elements, Input When in nonrevertive operation 1, a selected

cgmControlMIB Description

Table 5-4 cgmBitsTable (continued)

OID	MIB Object	Description	Access
.1.1.2.1.116	bitsTestPatternType	Determines the type of the generated test pattern.	r/w
		fixed(0) to use a pattern as defined in
		bitsTestPattern / bitsTestPatternLength.
		prbs11 (1)
		prbs15 (2)
		qrss20 (3)
		Default value is (1).
		Applies to the following line-type settings:
		dsx1ESF
		dsx1D4
		dsx1E1
		dsx1E1CRCMF
		dsx1E1unframed

The following table describes the elements of the cgmControl MIB branch (OID:.1.3.6.1.4.1.3656.8152.1.1).

Table 5-5 cgmControl Elements

OID	MIB Object	Description	Access
.1.1.10	cgmInterfaceMode	Defines Sonet/T1 (0) or SDH/E1 (1) operation	r/w
		mode for both BITS interfaces. Affects whether
		an input frequency of 1544KHz (Sonet/T1) or
		2048KHz (SDH/E1) can be selected for the
		cgmInputFrequency object.
		Default value is (1).
.1.1.15	cgmMasterSlaveShelfCombin	Defines whether the master/slave combination is	r/w
	ation	on the same shelf (0) or on different shelves (1).
		Note: only "same shelf" is supported.
		Default value is (0).
.1.1.16	cgmMasterSlaveSync	Defines the communication path to the protection	r/w
		partner.
		Default value is backplane (0).
.1.1.18	cgmProtectionRevertiveMode	When a clock module is in revertive operation	r/w
	State	(0), it will always choose the highest priority valid
		input.
		When in nonrevertive operation (1), a selected
		input will remain selected until it fails. The highest
		priority valid input will be chosen at that point and
		remain selected until it fails as well.
		Default value is (1).

PMC-CGM Installation and Use (6806800D53C) 53