IBM UPS1000THV, UPS750TLV, UPS1500TLV, UPS1000TLV, UPS750THV, UPS1500THV manual Battery Connection

Battery Connection

The battery connector is located on the rear panel (See Con- necting Equipment and Power to the Uninterruptible Power Supply).

For battery connection, push the connector into the corre- sponding port.

Connecting Equipment and Power to the Uninterruptible Power Supply

REAR PANEL

	750TLV				750THV		1000TLV AND			1000THV AND
	MODEL				MODEL		1500TLV			1500THV
						4	MODELS			MODELS
1	2	3 4	5	1	2		2 11 5	3	6	2 11	5	6
						5

6		8	9		7		9		4	12		8	9	4	12	7	10	9
	7			6		10					7
															1
INDEX			ITEM					DESCRIPTION		1
1 & 2			USB Port & Serial Port					Power management software and either USB or serial port commu-
								nication with the uninterruptible power supply can be used. Use only
								cables supplied or approved by IBM.

3Site Wiring Fault LED

4TVSS Screw

Use the supplied serial cable to connect to the serial port. DO NOT use a standard serial interface cable since it is incompatible with the uninterruptible power supply connector.

Important: Serial and USB ports cannot be used simultaneously.

750TLV, 1000TLV and 1500TLV models only: See Troubleshooting.

The uninterruptible power supply features a transient voltage surge- suppression (TVSS) screw for connecting the ground lead on surge suppression devices such as telephone and network line protectors.

When connecting a grounding cable, disconnect the unit from the utility power outlet.

5	Smart Slot	See Startup.
6	Battery Connector	See Battery Connection.
7	Outlet Banks	Connect equipment.
8	Input Cord	750TLV, 1000TLV and 1500TLV models only: See Startup.
9	Circuit Breaker	See Troubleshooting.
10	Input Connector	750THV, 1000THV and 1500THV models only: See Startup.

11Voltage Sensitivity Button and 1000TLV, 1000THV, 1500TLV and 1500THV models only: See User

LED Configurables.

12Telephone/Network Surge Sup- 1000TLV, 1000THV, 1500TLV and 1500THV models only: For tele-

pression Ports	phone/network surge suppression, connect a single line telephone or
	a 10Base-T/ 100Base-Tx network cable into the RJ-45/RJ-11 tele-
	phone/network surge protection port,	, on the back of the unin-
	terruptible power supply. Connect from the		port with sup-
	plied telephone or network cabling to a fax modem or network port.

5