Fujitsu 4Gbit/s FC I/O Modules manual Installation Position of the 4Gbit/s FC I/O Module

Page 12

2.1.1Installation Position of the 4Gbit/s FC I/O Module

The 4Gbit/s FC I/O Module is installed in the server blade expansion board slot.

Expansion board slot

2.1.2Installation Procedure for the 4Gbit/s FC I/O Module

1Turn off the server blade where the 4Gbit/s FC I/O Module will be

installed.

"3.3 Turning Off the Server" in "Blade Server System Unit Hardware Guide"

2Touch a metal part of the chassis to discharge static electricity from your body.

3Remove the server blade from the chassis.

"4.2 Installing Server Blades" in "Blade Server System Unit Hardware Guide"

4Remove the top cover.

"7.2 Removing and Attaching the Top Cover" in "Server Blade User's Guide"

50

Image 12
Contents Before Reading This Manual Symbols Entering Commands KeysKey Descriptions / Operations Abbreviations Handling this productChecking the Items Supplied Contents Page 4Gbit/s FC I/O Module OverviewSpecifications How to Check the Driver Version Points to Note When Using This Driver 4Gbit/s FC I/O Module to Eternus ConnectionsFabric connection Event logInstalling the 4Gbit/s FC I/O Module Installing in a Server BladeInstallation Position of the 4Gbit/s FC I/O Module Remove the top coverInstall the 4Gbit/s FC I/O Module Install the server blade in the chassisSecure the 4Gbit/s FC I/O Module with the screws Attach the top coverConnecting Cables This chapter explains points to note when connecting cablesInstalling Drivers and Utilities Automatic InstallationClick Finish Manual Installation Installing Emulex PlusSelect Emulex PLUS, and click Next Click Next Click Finish Installing *****port Miniport Driver Click the Driver tab and click Update DriverCheck the driver version Close the board property windowChecking and Updating Firmware / BootBIOS Click DownloadCheck the Revision value in Functional Firmware is Click the Download button Using HBAnyware Utility Click Update Firmware... in FirmwareUninstalling HBAnyware Uninstalling AutoPilot InstallerClick the Update Firmware... in Firmware 4Gbit/s FC I/O Module Details Setting 4Gbit/s FC I/O Module Setting Double-click QueueDepth in Parameters FC-ALSet a value in New Value, check Permanent, and click Change Check the parameters that have been set 4Gbit/s FC I/O Module Details Setting Select the local server, and click the Driver Parameters tab Connection type Value For ETERNUS4000 model 300/500 and ETERNUS8000 Specify Registry Setting After finishing all the settings, restart the server bladeFollow the paths below Troubleshooting How to start the Light Pulse Bios UtilityChecking the Link Status Troubleshooting Correctly? Guide provided with the serverAppendix a How to Identify the Adapter This chapter explains how to identify the adapterAppendix B Contact Information Page Issued on 発行責任