Fujitsu 4Gbit/s FC I/O Modules manual 4Gbit/s FC I/O Module Details Setting

Page 24

5 4Gbit/s FC I/O Module Details Setting

This chapter explains the 4Gbit/s FC I/O Module details settings.

When performing this product details settings, log on with administrative privileges.

When the connected device to this product is ETERNUS SX300, refer to the User’s Guide, etc. for ETERNUS SX300.

The setting effects are the same between the settings set by double-clicking [Device] of [key] after selecting [Registry] with the radio button in the LightPulse Utility/NT settings, and the settings set by the Global setting (checking [Global]) for all boards as described in this document.

For PG-FCD201, Adapter 0 and 1 are displayed.

62

Image 24

Contents Before Reading This Manual Symbols Entering Commands KeysKey Descriptions / Operations Abbreviations Handling this productChecking the Items Supplied Contents Page 4Gbit/s FC I/O Module OverviewSpecifications How to Check the Driver Version Points to Note When Using This Driver 4Gbit/s FC I/O Module to Eternus ConnectionsFabric connection Event logInstalling the 4Gbit/s FC I/O Module Installing in a Server BladeInstallation Position of the 4Gbit/s FC I/O Module Remove the top coverInstall the 4Gbit/s FC I/O Module Install the server blade in the chassisSecure the 4Gbit/s FC I/O Module with the screws Attach the top coverConnecting Cables This chapter explains points to note when connecting cablesInstalling Drivers and Utilities Automatic InstallationClick Finish Manual Installation Installing Emulex PlusSelect Emulex PLUS, and click Next Click Next Click Finish Installing *****port Miniport Driver Click the Driver tab and click Update DriverCheck the driver version Close the board property windowChecking and Updating Firmware / BootBIOS Click DownloadCheck the Revision value in Functional Firmware is Click the Download button Using HBAnyware Utility Click Update Firmware... in FirmwareUninstalling HBAnyware Uninstalling AutoPilot InstallerClick the Update Firmware... in Firmware 4Gbit/s FC I/O Module Details Setting 4Gbit/s FC I/O Module Setting Double-click QueueDepth in Parameters FC-ALSet a value in New Value, check Permanent, and click Change Check the parameters that have been set 4Gbit/s FC I/O Module Details Setting Select the local server, and click the Driver Parameters tab Connection type Value For ETERNUS4000 model 300/500 and ETERNUS8000 Specify Registry Setting After finishing all the settings, restart the server bladeFollow the paths below Troubleshooting How to start the Light Pulse Bios UtilityChecking the Link Status Troubleshooting Correctly? Guide provided with the serverAppendix a How to Identify the Adapter This chapter explains how to identify the adapterAppendix B Contact Information Page Issued on 発行責任