Fujitsu 4Gbit/s FC I/O Modules manual Click Finish

Page 16

1.Click [Next].

2.Select "Find the best driver for the device", and click [Next].

3.Check only "CD-ROM drive", and then click [Next].

4.Click [Next].

5.Click [Finish].

7Click [Finish].

When "System Settings Change" appears, click [Yes] to restart the system.

8Refer to "1.3 How to Check the Driver Version" (pg.47) to check the driver version.

When automatic installation finishes, perform "4.3 Checking and Updating Firmware /BootBIOS" (pg.58).

For details about the uninstallation procedure, refer to "4.4 Uninstalling HBAnyware" (pg.61) and "4.5 Uninstalling AutoPilot Installer" (pg.61).

54

Image 16

Contents Before Reading This Manual Entering Commands Keys SymbolsKey Descriptions / Operations Abbreviations Handling this productChecking the Items Supplied Contents Page 4Gbit/s FC I/O Module OverviewSpecifications How to Check the Driver Version Points to Note When Using This Driver 4Gbit/s FC I/O Module to Eternus ConnectionsFabric connection Event logInstalling the 4Gbit/s FC I/O Module Installing in a Server BladeInstallation Position of the 4Gbit/s FC I/O Module Remove the top coverInstall the 4Gbit/s FC I/O Module Install the server blade in the chassisSecure the 4Gbit/s FC I/O Module with the screws Attach the top coverConnecting Cables This chapter explains points to note when connecting cablesInstalling Drivers and Utilities Automatic InstallationClick Finish Installing Emulex Plus Manual InstallationSelect Emulex PLUS, and click Next Click Next Click Finish Installing *****port Miniport Driver Click the Driver tab and click Update DriverCheck the driver version Close the board property windowClick Download Checking and Updating Firmware / BootBIOSCheck the Revision value in Functional Firmware is Click the Download button Using HBAnyware Utility Click Update Firmware... in FirmwareUninstalling AutoPilot Installer Uninstalling HBAnywareClick the Update Firmware... in Firmware 4Gbit/s FC I/O Module Details Setting 4Gbit/s FC I/O Module Setting Double-click QueueDepth in Parameters FC-ALSet a value in New Value, check Permanent, and click Change Check the parameters that have been set 4Gbit/s FC I/O Module Details Setting Select the local server, and click the Driver Parameters tab Connection type Value For ETERNUS4000 model 300/500 and ETERNUS8000 Specify After finishing all the settings, restart the server blade Registry SettingFollow the paths below How to start the Light Pulse Bios Utility TroubleshootingChecking the Link Status Troubleshooting Correctly? Guide provided with the serverAppendix a How to Identify the Adapter This chapter explains how to identify the adapterAppendix B Contact Information Page Issued on 発行責任