Fujitsu 4Gbit/s FC I/O Modules manual Connecting Cables

Page 14

3 Connecting Cables

This chapter explains points to note when connecting cables.

Connect the cable to the FC Network Blade installed in the BX600 S3 chassis, or the port used by the FC Network Blade.

Each cable connector has a protrusion which determines the inserting direction of the connector. When connecting the cable, check this protrusion to make sure of the inserting direction of the connector, and then push the connector as far as it will go.

CAUTION

• Push each connector as far as it will go.

The connector may cause the system to malfunction, if it is not inserted properly.

•To disconnect the cable, always pull the connector not the cable. Pulling the cable may cause system failure.

•Since this product uses light for communication, be careful not to dirty the ends of its cable.

•Do not put any heavy objects on top of the cable, or bend it by force.

Doing so may cause failure or malfunction.

For details on how to connect the cables, refer to "SilkWorm 4016 Hardware Reference Manual" and "SilkWorm 4016 QuickStart Guide".

52

Image 14

Contents Before Reading This Manual Key Descriptions / Operations SymbolsEntering Commands Keys Abbreviations Handling this productChecking the Items Supplied Contents Page 4Gbit/s FC I/O Module OverviewSpecifications How to Check the Driver Version Fabric connection Points to Note When Using This Driver4Gbit/s FC I/O Module to Eternus Connections Event logInstalling the 4Gbit/s FC I/O Module Installing in a Server BladeInstallation Position of the 4Gbit/s FC I/O Module Remove the top coverSecure the 4Gbit/s FC I/O Module with the screws Install the 4Gbit/s FC I/O ModuleInstall the server blade in the chassis Attach the top coverConnecting Cables This chapter explains points to note when connecting cablesInstalling Drivers and Utilities Automatic InstallationClick Finish Select Emulex PLUS, and click Next Click Next Click Finish Manual InstallationInstalling Emulex Plus Installing *****port Miniport Driver Click the Driver tab and click Update DriverCheck the driver version Close the board property windowCheck the Revision value in Functional Firmware is Checking and Updating Firmware / BootBIOSClick Download Click the Download button Using HBAnyware Utility Click Update Firmware... in FirmwareClick the Update Firmware... in Firmware Uninstalling HBAnywareUninstalling AutoPilot Installer 4Gbit/s FC I/O Module Details Setting 4Gbit/s FC I/O Module Setting Double-click QueueDepth in Parameters FC-ALSet a value in New Value, check Permanent, and click Change Check the parameters that have been set 4Gbit/s FC I/O Module Details Setting Select the local server, and click the Driver Parameters tab Connection type Value For ETERNUS4000 model 300/500 and ETERNUS8000 Specify Follow the paths below Registry SettingAfter finishing all the settings, restart the server blade Checking the Link Status TroubleshootingHow to start the Light Pulse Bios Utility Troubleshooting Correctly? Guide provided with the serverAppendix a How to Identify the Adapter This chapter explains how to identify the adapterAppendix B Contact Information Page Issued on 発行責任