Fujitsu 4Gbit/s FC I/O Modules manual Installing Drivers and Utilities, Automatic Installation

Page 15

4 Installing Drivers and Utilities

This chapter explains the procedure for installing drivers and utilities.

When installing drivers, logon using administrator privileges.

•For installing drivers and utility (HBAnyware) at the same time. "4.1 Automatic Installation"(pg.53)

•For installing drivers and utility (HBAnyware) manually. "4.2 Manual Installation"(pg.55)

4.1Automatic Installation

The following shows the procedures for installing drivers and HBAnyware, using "AutoPilot Installer" that enables automatic installation.

If [Welcome to the Found New Hardware Wizard] appears during startup, click [Cancel].

1Insert the driver disk (CD-ROM) into the CD-ROM drive.

2Execute "EMCStorportMiniportKit_1-30a9-1b.exe" in the driver disk.

3Click [Next].

4Click [Install].

When the "EMC Storport Miniport Driver Kit 1.30a9-1b" window appears, click [OK].

5Confirm that "Start AutoPilot Installer" is checked, and then click [Finish].

"AutoPilot Installer" starts.

6Click [Next].

When the "Autopilot Installer Warning" window appears, click [Yes] or [OK] (This window may appear multiple times).

Installation process starts.

When the "Monitoring the Installation" window appears, click [Next].

When the "Welcome to the Found New Hardware Wizard" window appears, install as follows (this window may appear after restart).

E

4 Installing Drivers and Utilities 53

Image 15

Contents Before Reading This Manual Symbols Entering Commands KeysKey Descriptions / Operations Handling this product AbbreviationsChecking the Items Supplied Contents Page Overview 4Gbit/s FC I/O ModuleSpecifications How to Check the Driver Version Event log Points to Note When Using This Driver4Gbit/s FC I/O Module to Eternus Connections Fabric connectionInstalling in a Server Blade Installing the 4Gbit/s FC I/O ModuleRemove the top cover Installation Position of the 4Gbit/s FC I/O ModuleAttach the top cover Install the 4Gbit/s FC I/O ModuleInstall the server blade in the chassis Secure the 4Gbit/s FC I/O Module with the screwsThis chapter explains points to note when connecting cables Connecting CablesAutomatic Installation Installing Drivers and UtilitiesClick Finish Manual Installation Installing Emulex PlusSelect Emulex PLUS, and click Next Click Next Click Finish Click the Driver tab and click Update Driver Installing *****port Miniport DriverClose the board property window Check the driver versionChecking and Updating Firmware / BootBIOS Click DownloadCheck the Revision value in Functional Firmware is Click the Download button Click Update Firmware... in Firmware Using HBAnyware UtilityUninstalling HBAnyware Uninstalling AutoPilot InstallerClick the Update Firmware... in Firmware 4Gbit/s FC I/O Module Details Setting 4Gbit/s FC I/O Module Setting FC-AL Double-click QueueDepth in ParametersSet a value in New Value, check Permanent, and click Change Check the parameters that have been set 4Gbit/s FC I/O Module Details Setting Select the local server, and click the Driver Parameters tab Connection type Value For ETERNUS4000 model 300/500 and ETERNUS8000 Specify Registry Setting After finishing all the settings, restart the server bladeFollow the paths below Troubleshooting How to start the Light Pulse Bios UtilityChecking the Link Status Correctly? Guide provided with the server TroubleshootingThis chapter explains how to identify the adapter Appendix a How to Identify the AdapterAppendix B Contact Information Page 発行責任 Issued on