Fujitsu 4Gbit/s FC I/O Modules manual Troubleshooting, Correctly? Guide provided with the server

6.2Troubleshooting

Check the applicable items listed below if this product does not operate correctly. If the problem is not resolved even after taking the following measures, contact an office listed in "Appendix B Contact Information" (￿pg.75).

Symptoms	Items to be checked	Remedies
This product is not	Is the "!!! BX600-FC42E	If the message is not displayed, turn off the
recognized by the	BIOS, ***" message	server, open the cover, and check that the
server.	displayed at the startup of	4Gbit/s FC I/O Module is inserted properly in
	the server?*	an expansion board slot.
		￿"2 Installing the 4Gbit/s FC I/O
		Module"(pg.49)
	Is "Emulex *****"	If the message is not displayed, check that the
	displayed in the Device	driver is correctly installed.
	Manager when performing	￿"4 Installing Drivers and Utilities"(pg.53)
	the system from the
	Control Panel?
The device	Is the connected device to	Turn on the connected device to the board
connected to this	the board supplied with	first, and then turn on the server after
product cannot be	power?	connected device to the board has started up.
recognized.
	Are all cables connected	Check that all connectors are engaged
	correctly?	securely.
	Is the connected device to	Check the settings according to the manual for
	the board set up correctly?	connected device to the board.
This product does	Are all cables connected	Check that all connectors are engaged
not operate	correctly?	securely.
properly.
	Is the connected device to	Check the settings according to the manual for
	the board set up correctly?	connected device to the board.
	Is this product set up	Check the settings, using LightPulse Utility/
	correctly?	NT or HBAnyware Utility.
		￿"5 4Gbit/s FC I/O Module Details
		Setting"(pg.62)
	Is the server set up	Check the settings according to the "User’s
	correctly?	Guide" provided with the server.

*: If the expansion ROM initialization value where this product is installed is "Disable" the "!!! BX600-FC42E BIOS, ***" message will not be displayed at system startup. If starting this products BIOS is necessary, set the ROM (Option ROM SCAN) setting in this servers BIOS to "Enable".

E

6 Troubleshooting 73