Fujitsu 4Gbit/s FC I/O Modules manual Check the driver version, Close the board property window

Page 19

12Check the driver version.

•For 32Bit 5.1.30.9

•For 64Bit 7.1.30.9

13Close the board property window.

When installation finishes, perform "4.2.2 Installing HBAnyware" (pg.57).

4.2.2Installing HBAnyware

1Insert the driver disk (CD-ROM) into the CD-ROM drive, and execute "setupapps.exe" in the driver disk.

[CD-ROM drive]: \v1.30a9\AutoPilot Installer\Utilities\setupapps.exe

2Click [Next].

3Select "Full Management", check "Allow users to change management mode from utility.", and click [OK].

4Click [Finish].

When installation finishes, proceed to "4.3 Checking and Updating Firmware /BootBIOS" (pg.58). For details about the uninstallation procedure, refer to "4.4 Uninstalling HBAnyware" (pg.61).

E

4 Installing Drivers and Utilities 57

Image 19

Contents Before Reading This Manual Entering Commands Keys SymbolsKey Descriptions / Operations Handling this product AbbreviationsChecking the Items Supplied Contents Page Overview 4Gbit/s FC I/O ModuleSpecifications How to Check the Driver Version Event log Points to Note When Using This Driver4Gbit/s FC I/O Module to Eternus Connections Fabric connectionInstalling in a Server Blade Installing the 4Gbit/s FC I/O ModuleRemove the top cover Installation Position of the 4Gbit/s FC I/O ModuleAttach the top cover Install the 4Gbit/s FC I/O ModuleInstall the server blade in the chassis Secure the 4Gbit/s FC I/O Module with the screwsThis chapter explains points to note when connecting cables Connecting CablesAutomatic Installation Installing Drivers and UtilitiesClick Finish Installing Emulex Plus Manual InstallationSelect Emulex PLUS, and click Next Click Next Click Finish Click the Driver tab and click Update Driver Installing *****port Miniport DriverClose the board property window Check the driver versionClick Download Checking and Updating Firmware / BootBIOSCheck the Revision value in Functional Firmware is Click the Download button Click Update Firmware... in Firmware Using HBAnyware UtilityUninstalling AutoPilot Installer Uninstalling HBAnywareClick the Update Firmware... in Firmware 4Gbit/s FC I/O Module Details Setting 4Gbit/s FC I/O Module Setting FC-AL Double-click QueueDepth in ParametersSet a value in New Value, check Permanent, and click Change Check the parameters that have been set 4Gbit/s FC I/O Module Details Setting Select the local server, and click the Driver Parameters tab Connection type Value For ETERNUS4000 model 300/500 and ETERNUS8000 Specify After finishing all the settings, restart the server blade Registry SettingFollow the paths below How to start the Light Pulse Bios Utility TroubleshootingChecking the Link Status Correctly? Guide provided with the server TroubleshootingThis chapter explains how to identify the adapter Appendix a How to Identify the AdapterAppendix B Contact Information Page 発行責任 Issued on