Fujitsu 4Gbit/s FC I/O Modules manual Click the Download button

Page 21

7For the BootBIOS version, check the "Revision" value in "Boot Bios Firmware".

•When the version is "1.70a3", proceed to Step 11.

•When the version is other than "1.70a3", proceed to Step 8.

8Click the [Download] button.

Although the warning window appears, click [OK].

9Insert the driver disk (CD-ROM) into the CD-ROM drive, select the BootBIOS file in the CD-ROM drive, and click [Open].

[CD-ROM drive]:\FirmBIOS\ZB170A3.PRG BootBIOS update starts.

10Check that the "Revision" value in "Boot Bios Firmware" became "1.70a3".

For PG-FCD201, perform procedures as above to all adapter.

11After checking versions of all adapters, restart the server blade to enable the settings, and proceed to "5 4Gbit/s FC I/O Module Details Setting" (pg.62).

When replacing this product, perform "4.3 Checking and Updating Firmware / BootBIOS" (pg.58) again as necessary.

E

4 Installing Drivers and Utilities 59

Image 21

Contents Before Reading This Manual Symbols Entering Commands KeysKey Descriptions / Operations Handling this product AbbreviationsChecking the Items Supplied Contents Page Overview 4Gbit/s FC I/O ModuleSpecifications How to Check the Driver Version 4Gbit/s FC I/O Module to Eternus Connections Points to Note When Using This DriverFabric connection Event logInstalling in a Server Blade Installing the 4Gbit/s FC I/O ModuleRemove the top cover Installation Position of the 4Gbit/s FC I/O ModuleInstall the server blade in the chassis Install the 4Gbit/s FC I/O ModuleSecure the 4Gbit/s FC I/O Module with the screws Attach the top coverThis chapter explains points to note when connecting cables Connecting CablesAutomatic Installation Installing Drivers and UtilitiesClick Finish Manual Installation Installing Emulex PlusSelect Emulex PLUS, and click Next Click Next Click Finish Click the Driver tab and click Update Driver Installing *****port Miniport DriverClose the board property window Check the driver versionChecking and Updating Firmware / BootBIOS Click DownloadCheck the Revision value in Functional Firmware is Click the Download button Click Update Firmware... in Firmware Using HBAnyware UtilityUninstalling HBAnyware Uninstalling AutoPilot InstallerClick the Update Firmware... in Firmware 4Gbit/s FC I/O Module Details Setting 4Gbit/s FC I/O Module Setting FC-AL Double-click QueueDepth in ParametersSet a value in New Value, check Permanent, and click Change Check the parameters that have been set 4Gbit/s FC I/O Module Details Setting Select the local server, and click the Driver Parameters tab Connection type Value For ETERNUS4000 model 300/500 and ETERNUS8000 Specify Registry Setting After finishing all the settings, restart the server bladeFollow the paths below Troubleshooting How to start the Light Pulse Bios UtilityChecking the Link Status Correctly? Guide provided with the server TroubleshootingThis chapter explains how to identify the adapter Appendix a How to Identify the AdapterAppendix B Contact Information Page 発行責任 Issued on