Fujitsu 4Gbit/s FC I/O Modules Installing the 4Gbit/s FC I/O Module, Installing in a Server Blade

2 Installing the 4Gbit/s FC I/O Module

This chapter explains the installation procedure in the server blade.

WARNING

• When installing or removing this product, make sure to remove the server blade from the chassis. Failure to do so may cause electric shock.

For details on how to remove the server blade from the chassis, refer to "Blade Server System Unit Hardware Guide".

CAUTION

•The circuit boards and soldered parts of internal options are exposed. They can be damaged by static electricity. Before handling them, first touch a metal part of the server to discharge static electricity from your body.

•Do not touch the circuitry on boards or soldered parts. Hold the metallic areas or the edges of the circuit boards.

•These products are susceptible to static electricity. Place them on conductive pads or keep them in their packaging as long as they are not necessary.

2.1Installing in a Server Blade

￿Installing a FC Network Blade on chassis network blade slot 3 or network blade slot 4 is necessary in order to connect this product to the external FC-SW (device) or storage device.

￿When installing a server blade in the BX600 S2 chassis, this product cannot be installed in the server blade.

E

2 Installing the 4Gbit/s FC I/O Module 49