Fujitsu 4Gbit/s FC I/O Modules manual Troubleshooting, Checking the Link Status

Page 34

6 Troubleshooting

This chapter explains the troubleshooting methods when this product is not running properly or when error messages are displayed.

6.1Checking the Link Status

The link status connection can be checked upon system start by starting the Light Pulse BIOS Utility.

How to start the Light Pulse BIOS Utility

When this product is installed, the following message appears at the system startup.

!!!BX600-FC42E BIOS, Copyright (c) 2005 Emulex !!! Version 1.70a3 Press <ALT E> to go to Emulex BIOS Utility

Press <s> to skip Emulex BIOS

While the above message is displayed, pressing [Alt] + [E] keys makes the Light Pulse BIOS Utility start, and the following message appears.

Emulex Light Pulse BIOS Utility, ZB1.70A3

Copyright (c) 2006 Emulex Design & Manufacturing Corp

Emulex Adapters in the System:

1.BX600-FC42E: PCI Bus #:** PCI Device #:**

2.BX600-FC42E: PCI Bus #:** PCI Device #:**

Enter a Selection:

Enter <x> to Exit

To return from the Light Pulse BIOS Utility, press the [X] key.

Change the set value of the Light Pulse Bios Utility if necessary.

If the expansion ROM initialization value where this product is installed is "Disable" the "!!! BX600-FC42E BIOS, ***" message will not be displayed at system startup, and the BIOS cannot be started.

If starting this product's BIOS is necessary, set the ROM (Option ROM SCAN) settings in this servers BIOS to "Enabled".

72

Image 34

Contents Before Reading This Manual Entering Commands Keys SymbolsKey Descriptions / Operations Abbreviations Handling this productChecking the Items Supplied Contents Page 4Gbit/s FC I/O Module OverviewSpecifications How to Check the Driver Version Fabric connection Points to Note When Using This Driver4Gbit/s FC I/O Module to Eternus Connections Event logInstalling the 4Gbit/s FC I/O Module Installing in a Server BladeInstallation Position of the 4Gbit/s FC I/O Module Remove the top coverSecure the 4Gbit/s FC I/O Module with the screws Install the 4Gbit/s FC I/O ModuleInstall the server blade in the chassis Attach the top coverConnecting Cables This chapter explains points to note when connecting cablesInstalling Drivers and Utilities Automatic InstallationClick Finish Installing Emulex Plus Manual InstallationSelect Emulex PLUS, and click Next Click Next Click Finish Installing *****port Miniport Driver Click the Driver tab and click Update DriverCheck the driver version Close the board property windowClick Download Checking and Updating Firmware / BootBIOSCheck the Revision value in Functional Firmware is Click the Download button Using HBAnyware Utility Click Update Firmware... in FirmwareUninstalling AutoPilot Installer Uninstalling HBAnywareClick the Update Firmware... in Firmware 4Gbit/s FC I/O Module Details Setting 4Gbit/s FC I/O Module Setting Double-click QueueDepth in Parameters FC-ALSet a value in New Value, check Permanent, and click Change Check the parameters that have been set 4Gbit/s FC I/O Module Details Setting Select the local server, and click the Driver Parameters tab Connection type Value For ETERNUS4000 model 300/500 and ETERNUS8000 Specify After finishing all the settings, restart the server blade Registry SettingFollow the paths below How to start the Light Pulse Bios Utility TroubleshootingChecking the Link Status Troubleshooting Correctly? Guide provided with the serverAppendix a How to Identify the Adapter This chapter explains how to identify the adapterAppendix B Contact Information Page Issued on 発行責任