XP SBC HC 210.1 SRS
Installazione
Alimentazione della trasmittente
IMPORTANTE
Usare solamente l’adattatore Philips CA/CC 12 volt/200 mA, SBC CS30/00
1Assicuratevi che la tensione nominale dell’adattatore corrisponda a quella della presa.
Note:
Batterie completamente scariche hanno bisogno di circa 16 ore di ricarica.
Rimuovete sempre le batterie se la cuffia non viene usata per un lungo periodo di tempo.
Le batterie contengono delle sostanze chimiche, quindi vi raccomandiamo di smaltirle nel modo adeguato.
Italiano
2Collegate il connettore CC dell’adattatore CA/CC al connettore d’ingresso dell’alimentazione CC che si trova sul retro della trasmittente.
3Collegate l’adattatore CA/CC di
12 Volt/200 mA alla presa della rete.
–Scollegate sempre l’adattatore CA/CC se la trasmittente non viene usata per un lungo periodo di tempo.
Alimentazione della cuffia
IMPORTANTE
Utilizzate solamente batterie Philips SBC HB550S (R03/AAA NiMH).
1Controllate che il tasto dell’alimentazione della cuffia IR sia in posizione.
2Assicuratevi che le batterie vengano inserite correttamente come indicato dai simboli incisi nella sede delle batterie.
3Per ricaricare le batterie R03/AAA NiMH ricaricabili incorporate, spegnete prima la cuffia. Poi collegate il cavo di carica tra la cuffia e la trasmittente (figura 3). L’indicatore di ricarica si illumina.
Sostituzione delle batterie della cuffia (figura 4)
IMPORTANTE
Utilizzate solamente batterie Philips SBC HB550S (R03/AAA NiMH).
1Aprite lo scomparto batterie della cuffia.
2Estraete le batterie e smaltitele in modo adeguato.
3Utilizzate solamente batterie Philips SBC HB550S.
4Assicuratevi che le batterie vengano inserite correttamente come indicato dai simboli incisi nella sede delle batterie.
5Chiudete lo scomparto batterie.
IMPORTANTE
Prima di usare le cuffie IR per la prima volta, assicuratevi che le batterie siano completamente caricate per
16 ore. Questo garantisce una più lunga durata operativa delle batterie.
36