XP SBC HC 210.1 SRS
General information | Controls |
Surround sound SRS Headphone
The SBC HC 210 allows you to experience an
Auto mute for noise free operation
reduces the noise disturbance when the sound signal is too low or not available.
Neodymium speaker drivers
for faster bass response and lower overall distortion.
Kit contents
This IR headphone system consists of the following accessories:
1 x SBC HC212 IR transmitter
1 x SBC HC215 IR headphone
1 x SBC CS030/00 12 Volt/200 mA AC/DC adapter (for UK: SBC CS030/05
12 Volt/200 mA AC/DC adapter)
2 x Philips SBC HB550S rechargeable R03/AAA (NiMH) batteries
1 x 3.5 mm plug to 6.3 mm stereo adapter plug
1 recharge cable
Transmitter (figure 1)
1IR transmitting LEDs – transmit audio signal to IR headphone
2SRS Headphone surround sound button – push the button to switch on the SRS Headphone surround sound
(the SRS Headphone logo will light up when activated)
3Power indication – lights up when in use
4Power switch – power on/off switch
5Recharging output – connect the recharge cable to the output
6DC power – connect to the 12 Volt/ 200 mA AC/DC adapter
73.5 mm stereo headphone audio input – connects your IR transmitter to an audio source
Headphone (figure 2)
8IR sensors – to receive IR waves from the transmitter
9Power indication – lights up when in use
10Power On/Off – slide the switch to the on or off position to switch the headphone on/off
11Recharging indicator – lights up when the recharging cable is connected between the headphone and the IR transmitter.
Completely empty batteries will be fully charged after about 16 hours
12Recharging input (figure 3) – switch off the headphone prior to connecting the recharging cable to the transmitter.The recharging indicator on the headphone must light up, indicating that the headphone is being recharged
13Volume – adjust volume to your desired listening level
English
5