XP SBC HC 210.1 SRS
Installation
English
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00 12 Volt/200 mA AC/DC adapter. (For UK version: SBC CS030/05 12 Volt/200 mA AC/DC adapter)
1Make sure the adapter’s rated voltage corresponds to the mains socket voltage.
2Connect the DC connector of the AC/DC adapter to the 12 Volt DC power input connector located at the rear of the transmitter.
3Connect the 12 Volt/200 mA AC/DC adapter to the mains socket.
–Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time.
Headphone power supply
IMPORTANT
Only use Philips SBC HB550S batteries (R03/AAA NiMH).
1Check if the power button of the IR headphone is in the on position.
2Ensure the batteries are put in the battery compartment correctly according to the engraved polarity symbols.
3To recharge the headphone’s rechargeable R03/AAA NiMH batteries, first switch off the headphone.Then connect the charge cable between the headphone and the transmitter (figure 3).The recharging indicator will light up.
Note:
Completely empty batteries need approximately 16 hours to recharge.
Always remove the batteries if the headphone is not to be used for a long period of time.
Batteries contain chemical substances, so they should be disposed of properly.
Headphone battery replacement (figure 4)
IMPORTANT
Only use Philips SBC HB550S batteries (R03/AAA NiMH).
1Open the headphone’s battery compartment.
2Take out the batteries and dispose of them properly.
3Insert new batteries. Only use Philips SBC HB550S batteries.
4Make sure the batteries are correctly inserted as indicated by the engraved symbols in the battery compartment.
5Close the battery compartment.
IMPORTANT
Before using the IR headphone for the first time, please ensure that the batteries are fully charged for about 16 hours.This will guarantee a longer operating lifetime of the batteries.
6