<P=005>
SENDING DOCUMENTS
4 | START |
|
Press the START key. The document will be automatically transmitted once the connection is made.
Note: The SEARCH DIAL key can be used to access the first number in a Chain Dialing sequence, but not subsequent numbers.
Checking the telephone line status
The display normally shows the date and time and prompts related to operations you are performing. To check and see what number the fax is currently calling or transmitting to, or what number the fax is currently receiving a document from (if this information is available), press the CHANGEOVER key. Information on the current call will appear in the display. To switch back to the date and time display, press the CHANGEOVER key again.
To cancel a fax transmission or reception
To cancel a fax transmission or reception which is currently in progress, press the CHANGEOVER key so that the status of the transmission or reception appears in the display, and then press the STOP key.
Redialing
Automatic redialing
If you use automatic dialing (including Direct Keypad Dialing) and the line is busy, your fax will automatically redial the number. Your fax was set at the factory to make 2 redialing attempts at intervals of 5 minutes.
To stop automatic redialing, press the CHANGEOVER key to show the telephone line status in the display (make sure that RECALL MODE appears on the top line of the display and the number of the receiving party appears on the bottom line to the right), and then press the STOP key.
♦If desired, you can change the number of times the fax redials with Option Setting 6, and the interval at which redialing is done with Option Setting 7. See Chapter 5, "Optional Settings".
Using the REDIAL key
You can press the REDIAL key to redial the last number dialed. To send a document, proceed from Step 3 of Normal Dialing. Note that the speaker will be automatically activated, so you do not need to pick up the handset immediately.
BASIC OPERATIONS |