Runco DTV-947 manual Vertical corners, Fine Convergence Adjustments

Random Access Adjustment Mode

Vertical corners

Highlight ‘Vertical corners’ and press ENTER to start the adjustment.

CONVERGENCE

HORIZONTAL SIDES VERTICAL CORNERS

Select with or then <ENTER> <EXIT> to return

To make a coarse adjustment of the red or blue horizontal lines in zone 10, 14, 18 and 22 simultaneously.

Hint:

-Adjust until the red or the blue horizontal lines are on the green lines or as close as possible to the green lines.

-During these adjustments, the horizontal convergence adjustments in zones 10 to 25 will be set to midposition (barscale 50)

Fine Convergence Adjustments

Use these controls after coarse convergence adjustment to optimize the convergence of the red and blue image on the green image.

Use the control disk to make horizontal or vertical convergence adjust- ments in the selected zone and then press ENTER to move the box to another zone or EXIT to return to convergence menu.

ENTER toggles arrow keys between zone selection and zone adjustment. EXIT returns to convergence menu.

Note: The green convergence adjustments can be added as an option. When these are available, always start with ‘green only’. This option will also be indicated on the convergence menu.

Highlight first ‘Green only’ when available with the control disk and press ENTER to display the convergence adjustment menu.

Continue with red on green and blue on green.

CONVERGENCE

COARSE ADJUSTMENT

RED ON GREEN

BLUE ON GREEN

FINE ADJUSTMENT

CONVERGENCE

SEL : select area using arrow keys

ADJ : adjust area using arrow keys

Toggle between SEL and ADJ with <ENTER> <ENTER> continue <EXIT> to return

CONVERGE ADJUSTMENT

70

6-12