Runco DTV-947 manual Undo R & B convergence mid, Green convergence mid, Undo green convergence mid

Service Mode

Undo R & B convergence mid

When “R & B convergence mid” is selected, all convergence settings are set to their midposition. To cancel this action, select ‘Undo R & B convergence mid’ by pushing the control disc up or down and press ENTER. ‘Undo R & B convergence mid’ is displayed in the Memory management menu instead of ‘R & B conver- gence mid’ when this latter is pressed.

An undo is possible as long as the projector is playing on the same source (= same adjustment block) even when some adjustments are already readjusted. When undo is pressed all settings are reset to the previous settings.

Green convergence mid

Only available when the projector is equipped with green convergence adjust- ments.

Highlight ‘Gr convergence mid’ by pushing the control disc up or down and press ENTER to switch off the green convergence.

Undo green convergence mid

Only available when the projector is equipped with green convergence adjustment. The item ‘Undo green convergence mid’ will automatically be displayed when the green convergence is switched to midposition.

Press ENTER to switch on the green convergence.

Common Settings

Highlight ‘Common settings’ by pushing the control disc up or down and press ENTER to display the common settings menu.

Within the common settings menu, the following items can be set up or executed :

-G2 adjustment

-CRT run in cycle

-Projector warm up

-Memorybanks

MEMORY MANAGEMENT

COPY A BLOCK

DELETE A BLOCK

DELETE ALL BLOCKS

ALL SETTINGS TO MIDPOS

UNDO R & B CONVERGENCE MID

Select with or then <ENTER> <EXIT> to return.

MEMORY MANAGEMENT

COPY A BLOCK

DELETE A BLOCK

DELETE ALL BLOCKS

ALL SETTINGS TO MIDPOS

R & B CONVERGENCE MID

GR CONVERGENCE MID

Select with or then <ENTER> <EXIT> to return.

MEMORY MANAGEMENT

COPY A BLOCK

DELETE A BLOCK

DELETE ALL BLOCKS

ALL SETTINGS TO MIDPOS

R & B CONVERGENCE MID

UNDO GR CONVERGENCE MID

Select with or then <ENTER> <EXIT> to return.

SERVICE MODE

PROJECTOR SET-UP

MEMORY MANAGEMENT

COMMON SETTINGS 12C DIAGNOSTICS

Select with or then <ENTER> <EXIT> to return.

COMMON SETTINGS

G2 ADJUSTMENT

CRT RUN IN CYCLE

PROJECTOR WARM UP

MEMORYBANKS : ON

Select with or then <ENTER> <EXIT> to return.

7-8