AT&T Remote Port Security Device user manual Connecting the Rpsd Lock to the PBX Modem

Page 32

Modular

Plug

RJ11

Jack

	CO Line	Modular
	(RMATS Channel)
		Plug

FIGURE 2-5

RPSD Lock to CO Line (RMATS Channel)

Connecting the RPSD Lock to the PBX Modem

The 212A modem has a DB25 input, so the connection to the RPSD Lock must be adapted to connect the tip and ring from a modular plug to a DB25. The two relevant pins for the 212A are pins 7 and 8. Pin 7 is the tip and pin 8 is the ring. Connectors must be adapted to make this connection. A detailed description of this connection is in this chapter in the section titled Connecting the RPSD Lock to the Administration Terminal or Printer. Table 2-1provides the pinout for the Aux. Port. Further information, for either the 212A modem or any other modem, should be obtained from the documentation accompanying that modem.

The following components are needed to connect the RPSD Lock device to the PBX modem:

■RPSD Lock

■PBX modem assigned to the RMATS channel

■two modular connectors

■6 position wire

To connect the RPSD Lock device to the PBX modem, use the following procedure:

1Using either the 7-foot or the 14-foot cable with modular connectors on both ends which accompanied the Lock, insert one connector into the port on the back of the RPSD Lock device labeled Subscriber.

2Insert the other modular connector into the appropriate port on the PBX modem.

2-14Installation

Image 32

Contents AT&T Trademark Notice Important Safety Instructions Important Safety Instructions Part FCC NoticesPart 15, Subpart a Contents Rpsd System Administration Troubleshooting Cables, Connectors, and Ports TableRpsd Key Use Device LEDsList of Figures List of Tables Getting Started Getting Started Protection Process Rpsd Lock and Key Configuration Audience ResponsibilitiesThis Document Typographical ConventionsHotline or Other Service Call Numbers/Addresses 800Installation Installation 2Installation Power Supply Room Layout/EnvironmentLocation of Administration Terminal or Printer Hardware Components Rpsd LockRpsd Power Monitor Adapter Bypass Connections PBXs Rpsd Lock or Key Administration Terminal Rpsd Lock Administration PrinterOther ModemsRpsd Key Hardware Installation Procedures Installing the Rpsd LockCommon Rpsd Lock Configuration Connecting the Rpsd Lock to the CO Line Connecting the Rpsd Lock to the PBX Modem Rpsd Lock to Modem Rpsd Rpsd Lock to Administratlon Terminal or Printer DTE Powering Up the Rpsd Lock Installing the Rpsd Key Powering Up the Rpsd Key Connecting the Rpsd Key to the TerminalConnecting the Rpsd Key to the Modem Testing an Uninitialized Key Power-Up Behavior of Uninitialized KeyCables, Connectors, and Ports Table PBX24Installation Initializing the Rpsd Lock Aux. Port SettingsSoftware Components Initializing an Rpsd Key Test Rpsd Lock Installation Rpsd System Administration Time of Day Access System Activity Log Fields of the System Activity Log entries are Force Connect/Disconnect Single Point AdministrationEnable/Disable Block AT&T and Other Key Users Authorized Keys 6RPSD System Administration Syntax Rpsd System Administrator Command SetAdd User Sample Command and Response Without Optional Secret Key Sample Command and Response With Optional Secret KeyUnblock User Sample Command and ResponseBlock User Test User Remove UserFirst Sample Command and Response List User TableSecond Sample Command and Response User IDBlocked? Permanent?Third Sample Command and Response CR Change Restriction RestridStarthhmm Endhhmm Dayno LR List Restrictions N t aRestriction ID Start TimeUR User Restrictions LH Log History Fields of the Log History screen are Duration AH Access HistoryDevice # Reason FH Failure HistoryDate Time User ID Device # ST Status Display LS List Statistics RS Reset Statistics FC Force ConnectFD Force Disconnect Date SetClock Set ID SetSC Set Communications Parameters Help Screens Sample Help Request and Help ResponseRpsd Key Use Rpsd Key Use Access Failure Messages Last Call Status TestRpsd Key User Command Set Set User ID Set Secret KeySet Device Number List User InformationHistory Display 08/14/90 08/14/90 131413 Date Changed OK Set Log ID Status Display RPSD/KEY1110RPSD Key Use Wipe Out Troubleshooting Troubleshooting 2Troubleshooting Access Failure Messages Check described in Testing the Rpsd Lock Access Failure Messages Code Meaning Action 6Troubleshooting Testing the Rpsd Lock Built-in DiagnosticsSelf Check Last Call Status TestHardware Replacement Modem Ring TestReplacing the PBX Modem Replacing the Lock or Key 12Troubleshooting Saving the Key Seed Value Cables, Connectors, and Ports Table Xxxxxx PBX Device LEDs Front Panel LEDs Figure B-1AT&T Definity Rpsd Table B-2 Index Index2Index Index