AT&T Remote Port Security Device user manual Testing an Uninitialized Key

Page 40

Power-Up Behavior of Uninitialized Key

With an uninitialized Key, the left four LEDs will all light up upon power-up. If any other behavior occurs, there is a firmware error and the Key should be replaced.

Testing an Uninitialized Key

Test an RPSD Key that has not been initialized by connecting either a telephone or a terminal to the Subscriber port on the back panel of the Key, then dial the associated RPSD Lock, either directly via the telephone or via an application on the terminal. If the connection is good, the yellow Verify light comes on frost, followed by the green Connection light. This should occur in less than 30 seconds. The connection light will remain lit until the call is ended. If the connection fails, the red Idle light comes on.

2-22Installation

Image 40
Contents AT&T Trademark Notice Important Safety Instructions Important Safety Instructions Part 15, Subpart a FCC NoticesPart Contents Rpsd System Administration Troubleshooting Cables, Connectors, and Ports TableRpsd Key Use Device LEDsList of Figures List of Tables Getting Started Getting Started Protection Process Rpsd Lock and Key Configuration Audience ResponsibilitiesThis Document Typographical ConventionsHotline or Other Service Call Numbers/Addresses 800Installation Installation 2Installation Power Supply Room Layout/EnvironmentLocation of Administration Terminal or Printer Hardware Components Rpsd LockRpsd Power Monitor Adapter Bypass Connections PBXs Rpsd Lock or Key Administration Terminal Rpsd Lock Administration PrinterOther ModemsRpsd Key Hardware Installation Procedures Installing the Rpsd LockCommon Rpsd Lock Configuration Connecting the Rpsd Lock to the CO Line Connecting the Rpsd Lock to the PBX Modem Rpsd Lock to Modem Rpsd Rpsd Lock to Administratlon Terminal or Printer DTE Powering Up the Rpsd Lock Installing the Rpsd Key Connecting the Rpsd Key to the Modem Connecting the Rpsd Key to the TerminalPowering Up the Rpsd Key Testing an Uninitialized Key Power-Up Behavior of Uninitialized KeyCables, Connectors, and Ports Table PBX24Installation Software Components Aux. Port SettingsInitializing the Rpsd Lock Initializing an Rpsd Key Test Rpsd Lock Installation Rpsd System Administration Time of Day Access System Activity Log Fields of the System Activity Log entries are Enable/Disable Block AT&T and Other Key Users Single Point AdministrationForce Connect/Disconnect Authorized Keys 6RPSD System Administration Add User Rpsd System Administrator Command SetSyntax Sample Command and Response Without Optional Secret Key Sample Command and Response With Optional Secret KeyBlock User Sample Command and ResponseUnblock User Test User Remove UserFirst Sample Command and Response List User TableSecond Sample Command and Response User IDBlocked? Permanent?Third Sample Command and Response CR Change Restriction RestridStarthhmm Endhhmm Dayno LR List Restrictions N t aRestriction ID Start TimeUR User Restrictions LH Log History Fields of the Log History screen are Device # AH Access HistoryDuration Date Time User ID Device # FH Failure HistoryReason ST Status Display LS List Statistics RS Reset Statistics FC Force ConnectFD Force Disconnect Date SetClock Set ID SetSC Set Communications Parameters Help Screens Sample Help Request and Help ResponseRpsd Key Use Rpsd Key Use Access Failure Messages Last Call Status TestRpsd Key User Command Set Set User ID Set Secret KeySet Device Number List User InformationHistory Display 08/14/90 08/14/90 131413 Date Changed OK Set Log ID Status Display RPSD/KEY1110RPSD Key Use Wipe Out Troubleshooting Troubleshooting 2Troubleshooting Access Failure Messages Check described in Testing the Rpsd Lock Access Failure Messages Code Meaning Action 6Troubleshooting Testing the Rpsd Lock Built-in DiagnosticsSelf Check Last Call Status TestHardware Replacement Modem Ring TestReplacing the PBX Modem Replacing the Lock or Key 12Troubleshooting Saving the Key Seed Value Cables, Connectors, and Ports Table Xxxxxx PBX Device LEDs Front Panel LEDs Figure B-1AT&T Definity Rpsd Table B-2 Index Index2Index Index