RAD Data comm ASMI-450 operation manual Control Port Configuration Parameters

Front-Panel Operating Instructions

3.5 Control Port Configuration Parameters

Table 3-4 lists the available control port configuration parameters and their functions. The table also lists the parameter values included in the ASMi-450 default configuration.

In addition to the parameters listed below, the ASMi-450 supports additional parameters, which can be modified only via the control port. These parameters are explained in Chapter 4.

Table 3-D. Control Port Parameters

Designation	Function			Values
SPEED BPS	Selects control port	300,
	data rate	1200,
		2400, Control port data rate (bps)
		4800,
		9600
		AUTO	Autobaud operation. The ASMi-450 automatically
			identifies the control port data rate.
			To enable positive identification the transmission must
			start with three consecutive Carriage Returns.
		Default: AUTO
DATA	Selects the number of	7 or 8 data bits.
	data bits in the word
	format	Default: 8
PARITY	Controls the use of	ODD	Odd parity
	parity	EVEN	Even parity
		NONE	Parity disabled (only available with 8 data bits)
		Default: NONE
INTERFACE	Selects control port	DCE	The ASMi-450 appears as a DCE for the control terminal
	interface	DTE	The ASMi-450 operates as a DTE for connection via
			modem to the control terminal (future option)
		Default: DCE
AUX DEV	Selects an auxiliary	TERMINAL		Management by means of supervision terminal
	device	NMS-SLIP		Management by means of TCP/IP over SLIP
				(Telnet or SNMP)
		NONE		Not in use
		Default: TERMINAL

ASMi-450 Installation and Operation Manual 3-9