RAD Data comm ASMI-450 operation manual Pwd

ASMi-450 Control from the Control Port

Notes

In addition to the parameters listed in Section 3-5, the following parameters can be programmed only from the terminal:

PWD	Password protection: select YES or NO
LOG_OFF	Idle disconnect time:
	NO	automatic session disconnection disabled.
	10_MIN	automatic disconnection after ten minutes if no input
		data is received by the ASMi-450.
CTS	Determines CTS state:
	ON	The CTS line is always ON (active).
	=RTS	The CTS line follows the RTS line.
DCD_DEL	With ASMi-450 control port defined as DTE, indicates delay (in
	msec) between DCD=ON and the sending of data.
	Values: 0, 10, 50, 100, 200, 300 msec.
POP_ALM	Controls the automatic display of alarms in the terminal
	YES	The terminal automatically displays every 10
		minutes the alarm status (or whenever an alarm
		changes state to ON)
	NO	The automatic display feature is disabled
DSR	Determines the DSR state:
	ON	The DSR line is continuously on. It will switch to
	OFF	for five seconds after the DTR line is switched OFF.
	DTR	The DSR line tracks the DTR line. When
		INTERFACE=DTE, the DSR line will switch to ON
		for five seconds when the RI line is ON while the
	DTR	line is OFF.
AUXILIARY	Selects the management mode supported by the control port of
DEVICE	the ASMi-450:
	TERMINAL management by means of a supervision terminal.
	NMS_SLIP	management by means of Telnet host, or an
		SNMP network management station.

6.After the desired parameter values are selected, press <CR> to end. The ASMi-450 will display the TIME and DATE fields, followed by the ASMi-450 prompt.

4-14 ASMi-450 Installation and Operation Manual