RAD Data comm ASMI-450 operation manual Help, Purpose Format Use

ASMi-450 Control from the Control Port

F--------------------------------------------------------------------------------------------------

Purpose

Format

Use

Define the codes used to be sent to the control terminal to perform the following terminal control functions:

∙Clear screen

∙Move cursor to screen home position.

∙Move cursor to the right by one position.

This command lets you enter manually the desired codes. However, if you are using a terminal of the following type: VT-52, VT-100, TV-920, FREEDOM-110, FREEDOM-220, or a terminal which is compatible with one of the terminals listed above, you can use the DEF TERM command (see DEF TERM command) to select automatically the corresponding control sequences.

F

1.To display the current codes, type:

F<CR>

2.The terminal function entry screen is displayed. The screen includes three separate lines, displayed one after the other. A typical screen, showing all the three lines, is shown below:

CLEAR SCREEN		=hhhhhhhh (clear screen code)
CURSOR	HOME	=hhhhhhhh	(cursor	home code)
CURSOR	RIGHT	=hhhhhhhh	(cursor	right code)

where h indicates hexadecimal digits.

3.To change a code, bring the cursor under the first digit of the code to be changed, by pressing <CR>, then enter the appropriate hexadecimal digit.

4.Repeat the procedure until all the necessary digits are changed.

HELP -------------------------------------------------------------------------------------------

Purpose	Display an index of the control port commands and the options available for each
	command.
Format	H<CR>
& Use
	You will see the first HELP page. Press any key to see the next page.

4-22 ASMi-450 Installation and Operation Manual