RAD Data comm ASMI-450 operation manual Alarm No Alarm Syntax Meaning State Time

ASMi-450 Control from the Control Port

Table 4-B. Control Terminal Alarm Messages

Alarm No.	Alarm Syntax	Meaning	State	Time
1	LOCAL DB	The data base currently stored in the non-	[ON]	hh:mm:ss
	CHECKSUM ERROR	volatile memory of the local ASMi-450 is
		corrupted. Message can appear only upon
		power-up
2	LOCAL ALARM	The alarm buffer of the local ASMi-450 is	[ON] [OFF]	hh:mm:ss
	BUFFER OVERFLOW	full, and new alarms overwrite the older
		alarms
3	LOCAL SELF TEST	A fault has been detected in the local	[ON]	hh:mm:ss
	ERROR	ASMi-450 during the power-up self-test
4	LOCAL HARDWARE	A hardware fault has been detected in the	[ON]	hh:mm:ss
	FAILURE	local ASMi-450
5	LOCAL PSWRD	Section PSWD of switch S1 of the local	[ON]	hh:mm:ss
	SWITCH IS ON	ASMi-450 is set to ON
6	LOCAL SP-PAR	Section DEF SP of switch S1 of the local	[ON]	hh:mm:ss
	SWITCH IS ON	ASMi-450 is set to ON
7	LOCAL DB-INIT	Section DB INIT of switch S1 of the local	[ON]	hh:mm:ss
	SWITCH IS ON	ASMi-450 is set to ON
8	LOCAL REAL TIME	The battery that powers the local	[ON]	hh:mm:ss
	CLOCK BATTERY	ASMi-450 internal real-time clock when
	FAILURE	ASMi-450 is not powered has failed
9	LOCAL REVERSE	Reversed loop polarity has been detected	[ON]	hh:mm:ss
	POLARITY	by the local ASMi-450
10	LOCAL SIGNAL LOSS	Loss of HDSL line input signal at the local	[ON] [OFF]	hh:mm:ss
		ASMi-450
11	LOCAL SYNC LOSS	The local ASMi-450 lost synchronization	[ON] [OFF]	hh:mm:ss
		to the HDSL line signal
12	LOCAL LOW QUALITY	The CRC-6 error rate detected on the	[ON]	hh:mm:ss
	ALARM	incoming HDSL signal exceeds 10-7
13	LOCAL TRANSMIT	A slip has been detected on the local	[ON]	hh:mm:ss
	SLIP	transmit path
14	LOCAL RECEIVE SLIP	A slip has been detected on the local	[ON]	hh:mm:ss
		receive path
15	LAN NOT CONNECTED	No data is received from the user's port	[ON] [OFF]	hh:mm:ss
		(for ASMi-450 version with serial data
		port).
		or
		The Ethernet interface is not connected to
		an operating LAN (at least one station
		must be active on the LAN)

ASMi-450 Installation and Operation Manual 4-17