RAD Data comm ASMI-450 operation manual Dsp St Sys, Exit

ASMi-450 Control from the Control Port

	on the remote unit.
REMOTE UNIT	Displays the state of the loopback that can be
INITIATED LOOPS	activated by command from the remote
	ASMi-450 unit on the local unit (this is REM
	PORT, remote port loopback on the local unit,
	toward the remote unit).
DSP ST SYS----------------------------------------------------------------------------------

Purpose

Format

Use

Display Format

Display system status information.

DSP ST SYS [option]

To view the current system status, type:

DSP ST SYS<CR>

A typical status information display is shown below.

NODE	=	0
NAME	= 'ASMi-450 name'
NODAL CLOCK	=	EXT
ASMI TYPE	=	CNTR
NUM OF ACTIVE TS = 24
SOFTWARE REV	=	X.Y
HARDWARE REV	=	X.Y

The system status fields are described below (from top to bottom)

NODE	Displays the node number of the ASMi-450
NAME	Displays the node name of the ASMi-450
NODAL CLOCK	Indicates the current source for the ASMi-450 system clock:
	INT or EXT (see Section 3-4).

NUM OF ACTIVE TS Indicates the number of active time slots configured on the

	ASMi-450 (see Section 3-4).
ASMI TYPE	Indicates the function of the ASMi-450: central or remote.
SOFTWARE REV	Displays the ASMi-450 software version
HARDWARE REV	Displays the ASMi-450 hardware version

EXIT---------------------------------------------------------------------------------------------

Purpose	End the current session and return control to the ASMi-450 front panel.
Format	EXIT
Use	Type:
	EXIT<CR>

ASMi-450 Installation and Operation Manual 4-21