
4.5 ASMi-450 Command Set Description
This section describes the
The following notational conventions are used below:
[ | ] | square brackets indicate optional entry/parameter |
' | ' | single quotes delimit user entry |
<CR> | indicates the pressing of the carriage return key |
CLR ALM --------------------------------------------------------------------------------------
Purpose | Clear the alarm buffer. | |
Format | CLR ALM [/A] | |
Use | 1. | To clear only alarms of the ON type stored in the alarm buffer (see Table |
|
| CLR ALM<CR> |
| 2. | To clear all the alarms stored in the alarm buffer (including ON/OFF alarms): |
|
| CLR ALM /A<CR> |
| 3. | You will see the time and date, followed by the |
CLR LOOP ------------------------------------------------------------------------------------
Purpose | Deactivate the specified | |
Format | CLR LOOP [looptype] or CLR LP [looptype] | |
Use | 1. | To deactivate the local (L) loopback on the user's port of the local |
|
| CLR LOOP L PORT<CR> or CLR LP L PORT<CR> |
| 2. | To deactivate the remote (R) loopback on the user's port of the remote |
|
| type: |
|
| CLR LOOP R R PORT<CR> or CLR LP R R PORT<CR> |
| 3. | You will see the time and date, followed by the |
| 4. | If no loopback of the specified type is now activated, you will receive ERROR 2. |