Technical Features
Preset and user modes
When the monitor receives an input signal, it automatically matches the signal to one of the factory preset modes stored in the monitor’s memory to provide a high quality picture at the center of the screen. (See Appendix for a list of the factory preset modes.) For input signals that do not match one of the factory preset modes, the digital Multiscan technology of this monitor ensures that a clear picture appears on the screen for any timing in the monitor’s frequency range (horizontal: 30 – 70 kHz, vertical: 48 – 120 Hz). If the picture is adjusted, the adjustment data is stored as a user mode and automatically recalled whenever the same input signal is received.
Note for Windows users
For Windows users, check your video board manual or the utility program which comes with your graphic board and select the highest available refresh rate to maximize monitor performance.
Troubleshooting
Before contacting technical support, refer to this section.
If thin line appears on your screen (damper wire)
The visible line on your screen especially when the background screen color is light (usually white), is normal for the Trinitron monitor. This is not a malfunction. This is shadow from the damper wire used to stabilize the aperture grille. The aperture grille is the essential element that makes a Trinitron picture tube unique by allowing more light to reach the screen, resulting in a brighter, more detailed picture.
Damper wire
Power saving function
This monitor meets the
Power mode | Power | 1 (power) indicator |
| consumption |
|
|
|
|
normal | ≤ 95 W | green |
operation |
|
|
|
|
|
active off* | ≤ 5 W | orange** |
|
|
|
power off | 0 W | off |
|
|
|
*When your computer enters the “active off” mode, the input signal is cut and NO INPUT SIGNAL appears on the screen. After 20 seconds, the monitor enters the power saving mode.
**If the horizontal or vertical sync signal is received by the monitor, the power indicator may alternately blink green and orange.
On-screen messages
If there is something wrong with the input signal, one of the | US | |||
following messages appears on the screen. To solve the problem, |
| |||
see “Trouble symptoms and remedies” on page 14. |
| |||
|
|
|
|
|
| INFORMATION |
|
| |
|
| Input signal |
| |
| OUT OF SCAN RANGE |
|
| |
|
|
| condition |
|
|
|
|
| |
|
|
|
|
|
The input signal condition
OUT OF SCAN RANGE
indicates that the input signal is not supported by the monitor’s specifications.
NO INPUT SIGNAL
indicates that no signal is being input to the monitor.
13