Panasonic DA-PC700 manual Using the Internet Printing Protocol 133, Define the IP address

Page 147

9.1 Introduction

9.1.2Setup

Procedure

Define the IP address.

"1.6 Setting IP Address For Network Environment"

At the printer, select Tools Mode, Print/Scan Mode Settings, Port Settings,

Internet Service, Enable (factory setting: Enable).

"Chapter 13 Configuring by the Tools Mode Screen"

At the computer and on the Internet Services screen, select the Properties tab, Port Status, and then check the Enable (factory setting: Enable) check box for IPP.

At the computer, setup the printer and install the driver.

"Chapter 4 Installing and Configuring Printer Drivers"

9

Using the Internet Printing Protocol

133

Page 146 Page 148
Image 147
Page 146 Page 148
Contents DA-PC700 TRADEMARKS/COPYRIGHTS Preface Types of Manuals Manual bundled with the main unit i.e. the copierManuals bundled with the Printer/Scanner Unit Using These Operating Instructions OrganizationIii Precautions and Limitations Using Internet ServicesSetting Print Mode Configuring by the Tools Mode ScreenAll kinds of buttons e.g. Click OK ConventionsIcons used in this manual Bold facePrecaution for power and earth connection Safety NotesTable of Contents Chapter Installing/ Configuring the Printer Drivers Setup for the Direct Print UtilityViii Chapter Setup for TCP/IP Windows NT/Windows Setup for Windows NetworkingSetup for NetWare Chapter Printing Reports/Lists Chapter Using the Internet Printing ProtocolUsing Internet Services Setting Print ModeConfiguring by the Tools Mode Screen Precautions and LimitationsChapter Troubleshooting Appendix XiiOverview of the Printer Back View Parallel interface connectorEthernet interface connector Main Components and Their FunctionsOverview of the Printer Using the Touch Panel DisplayConnect the cable and make the necessary set- tings Getting Ready to PrintWhen connecting to a network Special Features Printer Setting Printer Environment Network Printer Environments TCP/IP Direct Print Utility for Windows 95/98/Me TCP/IP for Windows NT 4.0/Windows NetWare AppleTalk for MacintoshToken Ring Internet printingSetting IP Address for Network Environment Flow of SettingSetting method Select Print/Scan Mode Settings Using Touch Panel Display for SettingSetting IP address/subnet mask/gateway address ProcedureSelect Specify Address Select Network SettingsTouch Exit Tools Machine will be rebootedChecking/Setting Dhcp Environment Activating Port Setting PortSelect Print/Scan Mode Settings Select Port Settings Select Port Status and then touch Change SettingsSelect LPD Select Save Select Close twice Select EnableSelect Exit Tools Other setting itemsPower Saver Using the Power Saver ModeAutomatic Power Saver Mode CD-ROM About the AttachedThis page is intentionally left blank Setup Parallel Connecting Interface CablesSetup EthernetEthernet interface supports the following types of cable Memory Allocation UsesSuggested Values Useful Operations For Windows Flow of PrintingBasic Way of Printing Online HelpUseful Operations Checking Job Status Check the contents and touch ExitCancelling Jobs in Process Cancelling Printing From PrinterCancelling Jobs in the Printer Outputting Waiting Jobs Forced OutputtingOutputting in Emulation Mode Select Print Mode Switching Printer to OfflinePrinting vs Copying Scanning This page is intentionally left blank This page is intentionally left blank This page is intentionally left blank This page is intentionally left blank Installing Configuring Printer Drivers About the Printer Drivers Installation/Configuration MethodsSettings on the Printer Select Print/Scan Mode SettingInstalling/Uninstalling Printer Drivers Installing/Configuring the Printer DriversFor a Local Printer Installing/Uninstalling the Printer Drivers For Windows 95/98/Me Click Add Network Port For a Network PrinterUninstalling the Printer Drivers Installing/Uninstalling the Printer Drivers Configuring the Printer Drivers Accessing the Printer Properties Dialog BoxFor Windows 95/98/Me For Windows NT 4.0/Windows Accessing the printer properties dialog boxSetting the Printer Properties Printer Paper Source OptionsPaper Output Options Restore Defaults Error ReportJob Owner Settings Auto ConfigurationJob Type Paper/OutputPaper Source Paper SizePaper sizes available for each paper source are as follows Output DestinationCustom Paper Size Copies defaultImage Orientation Sided PrintCollate Settings Output OptionsFinishing Apply one staple at the bottom-left corner of paper Apply one staple at the top-right corner of paperApply two staples at the left edge of paper Apply two staples at the right edge of paperPunch Position First Sheet EMF Spooling for Windows NT 4.0/Windows 2000 default offGraphics Mode GraphicsHalftone Use Printer TrueType Fonts default on Image Enhancement default onAll Texts to Black default off TrueType ModeCreate Overlay Halftone Color Adjustment for Windows NT 4.0/WindowsOverlays Load OverlaySelected Overlay status Delete OverlayDelete All Query Page OverlayNo page border is drawn Layout ModeMulti-Upavailable when Multi-Upis selected for Layout Mode LayoutBooklet Creation Top Left Top Right Center default Bottom Left Bottom Right Zoom available when Zoom is selected for Layout ModeCustom None defaultPoster available when Poster is selected for Layout Mode ShadowWatermarks Procedure to create a watermark is as followsProcedure to edit a watermark is as follows Procedure to delete a watermark is as followsBackground To print a watermark, the options available includeThis page is intentionally left blank Setup for Direct Print Utility Target computers must meet all the following requirements Using the Direct Print UtilitySystem Configuration Target Computers Windows 95/98/MeSetup for the Direct Print Utility Flow of SetupWhen the LPD Port is Disabled Setup of the PrinterSetup of the Printer Other Settings Overview Installing the Direct Print UtilitySetting the TCP/IP Protocol Procedure to install the Direct Print Utility is as follows Installation ProcedureRestart the system for the installation to complete Setting the Port Click Add Port Click the Details tabPort Name Enter a name for identifying the printerIP Address Status Indication Status Indication Uninstalling Uninstalling This page is intentionally left blank TCP/IP Setup for TCP/IP Windows NT/Windows Setup for the Printer Setting the LPD Port to EnableWindows NT/Windows Setup for TCP/IP 2000 Setup for the Printer Windows NT/Windows Setup for TCP/IP 2000 Select Exit Tools Other Settings Setup for Windows NT For Windows NT 4.0/Windows100 Setup for Windows Networking Introduction System Structure102 Setup Procedure 103 Setup for Windows NetworkingInstall the printer driver to the host computer Setting NetBEUI in Printer Activating Port and Setting Protocol104 Select SMB 105 Setup for Windows Networking106 107 Setup for Windows Networking Setting TCP/IP in Printer Defining IP Address108 109 Setup for Windows Networking 110 Refer to 7.2.2 Other Settings111 Setup for Windows Networking Changing Printer Workgroup NameThrough Windows Networking Close message.txt 112Setting format of config.txt 113Activation of NetBEUI protocol On/Off Activation of Dhcp On/Off Wins Dhcp Resolve 114Example of config.txt 115 Setup for Windows NetworkingAuto Driver Downloading Preparation for Auto Driver Downloading116 117 Setup for Windows Networking 118 Auto Downloading of Printer Driver119 Setup for Windows Networking 120 Setup for NetWare Target computers must meet the following requirements Using NetWareTarget Computers 122Following frame types are supported Setup for NetWare 123Interface Printer supports the following types of Ethernet interface124 Setup for NetWareSetting the Port to Enable Setup for NetWare 125Activate the NetWare¨ port by the following procedure Select NetWare 126Setup for NetWare 127 128 Printing the Printer Settings ListSetup for the Client Setup for NetWare 129Windows 95/98/Me, Windows NT 4.0 or Windows This page is intentionally left blank Using Internet Printing Protocol System Environment 132Essential system environment is as follows Define the IP address Using the Internet Printing Protocol 133IPP DNS 134Using the Internet Printing Protocol 135 Setup of the Printer Installing the Printer Driver136 Screen to select the printer driver appears Using the Internet Printing Protocol 137Click Have Disk Manufacturers files from, and then click OK138 Using Internet Services Using Internet Services Structure of the Internet Services Screen140 Browsers Using Internet Services 141Target Host Computers and Browsers Host computersFor Netscape Communicator Configuring BrowserChecking Browsers 142Checking Proxy Server and Port Number Using Internet Services 143Proxy server setting Port number settingConfiguring Printer Activating Internet Service144 Select Enable and then touch Save Using Internet ServicesSelect Port Settings Select Internet Service With Port Status selected, touch Change SettingsOther Internet Service Settings Items 146Select Close twice until the screen at is displayed Using Internet Services 147 Activating BrowserActivating Browser Screen of the Internet Services is displayed Help148 Setting Print Mode 150 Print Mode OperationMenu Item Description PCL 6 SettingsList of PCL 6 Settings Items Setting Print Mode 151152 Setting Print Mode 153 ISO-6 ISO 6 Ascii 154Spaced font is selected Setting Print Mode 155156 Setting ProcedureSelect Print Mode from the menu screen Touch PCL6 SettingsSetting Print Mode 157 This page is intentionally left blank Printing Reports/Lists Types Types of Reports/ListsTypes and Paper Sizes 160Printing result Printer Settings ListAbout Printer Settings List Printing Reports/Lists 161162 Job History Report Printing Reports/Lists 163About Job History Report ERR 164Printing Reports/Lists 165 166 Error History ReportAbout Error History Report Prints information related to printer errorsPrinting Reports/Lists 167 168 PCL Settings ListAbout PCL Settings Prints the PCL settings of the printerPrinting Reports/Lists 169 PCL Fonts List 170About PCL Fonts List Printing Reports/Lists 171 PostScript Fonts List 172About PostScript Fonts List Printing Reports/Lists 173 Print Meter Report 174About Print Meter Report Printing Reports/Lists 175 PostScript Settings List About PostScript Settings List176 Printing Reports/Lists 177 Following items will be included in the list Mailbox Size Stored Print Job List178 About Stored Print Job ListPrinting Reports/Lists 179 How to Print Report/List 180Select Print Report/List Configuring By the Tools Mode Screen Tools Mode Displaying the Tools Mode Screen182 183 Exiting the Tools Mode ScreenConfiguring by the Tools Mode Screen Select Exit Tools on the Tools Mode screenSystem/Meter Settings Common Settings184 Configuring by the Tools Mode Screen 185 186 Copy Mode SettingsConfiguring by the Tools Mode Screen 187 Print/Scan Mode SettingsInput no more than 12 characters from A-Z, 0-9 and space 188Configuring by the Tools Mode Screen 189 SMB 190Connected to any other salutation protocol Configuring by the Tools Mode Screen 191IPP 192Configuring by the Tools Mode Screen 193 194 Configuring by the Tools Mode Screen 195 196 Select Enable Select SavePrecautions Limitations General When switching on/off powerWhen cancelling printing When initialized hard diskWhen using the finisher with the puncher attached Precautions and Limitations 199On Using NetWare Setting Printer200 For Bindery Setting ServerPrecautions and Limitations 201 For NDS202 Using Token Ring Interface PortDuring Printing OthersPrecautions and Limitations 203 On Using TCP/IP LPDDuring Setup During Switching Power On/OffTake note of the following when printing When LPD Spool is set to Off non-spool modeWhen LPD Spool is set to Hard Disk or Memory spool mode When the IP address or computer name is changedOn Using SMB Precautions and Limitations205 Deleting jobs When SMB Spool is set to Hard Disk or Memory spool modeWhen printer is in offline mode 206Troubleshooting Condition Cause Treatment When Problems OccurExit the Tools Mode screen 208Troubleshooting 209 210 Raster for Graphics Mode. OrStop Troubleshooting 211 Tray will result in paperJam. Or the message Put XX-sized paper is Displayed 212 When the Print Quality is PoorPaper used is not suitable Replace with suitable paper Troubleshooting 213214 Paper has moisture Replace with new paper Troubleshooting 215216 Unable to print Network ErrorFollowing port . Click Spool Settings to display its Troubleshooting 217Printer is not Printing 218Cause Verification Action Troubleshooting 219 Set NCP Packet Signature Option=X X 0, 1 or 220When Switch Off the Power Appears Troubleshooting 221Unable to Obtain Desired Print Results 222 No NotificationUsing TCP/IP When Using Windows 95/98/MeTroubleshooting 223 Unable to obtain the desired print results When Using Windows NTWhen the printer is not printing 224Using SMB Troubleshooting 225Printer is not Found Cannot Print Cannot Delete Documents from the Printer Window226 Cannot Perform Auto Driver Downloading Troubleshooting 227228 Appendix Main Specifications Specifications of the Printer230 Appendix 231 Printing AreaPin arrangement Connectors and Allocation SignalShape of the connector 232Meaning of the signals All connections adhere to the Ieee 1284 connector standardAppendix 233 234 Using OverlaysPrinting Data Combined Creating an OverlayPrinting with an Overlay Appendix 235Next, print your data with the overlay Secured Print Printing Secured PrintSample Set Jobs 236Appendix 237 Storing Secured Print/Sample Set Jobs238 Printing Secured Print/Sample Set JobsAppendix 239 Following screen appears For Secured Print job 240Glossary Glossary241 242 243 SymbolIndex IndexIndex 244245 This page is intentionally left blank Memo Warranty
Related manuals
Manual 65 pages 24.1 Kb
Top Page Image Contents