EX 5/7/11RT Systems
NOTE: | This step is unique to the Power Module. It involves the installation of the I/O Box |
| Bracket System. |
|
|
The I/O Box bracket system keeps the I/O Box stationary while hot swapping the Power Module. It will then be easier to slide the replacement module into the connectors of the I/O Box.
1&2. Secure small brackets to larger bracket from the underside 27 .
3.Secure small attached brackets to the I/O Box with four screws.
4. Secure large bracket 27 to rails at the rear of module with four nuts.
Figure 2-7: Input/Output Box Bracket System.
1
2
4
4 
3
Install input/output cables
per section 2.7 prior to this step.
2 — 8 | Installation |