MGE UPS Systems EX-5, EX-7, EX-11RT manual Iec

Page 72

EX 5/7/11RT Systems

dBrnC

Decibel above reference noise.

DC or dc

Direct current, or voltage.

Earth ground

A ground circuit that has contact with the earth.

Electrician

Refers to an installation electrician qualified to install heavy-duty electrical components in

 

accordance with local codes and regulations. Not necessarily qualified to maintain or repair

 

electrical or electronic equipment.

FET

Field effect transistor.

Freq.

Frequency.

Frequency slew rate

The change in frequency per unit of time. Given in term of Hz per second (Hz/sec.).

GND

Ground (safety).

Hz

Hertz, frequency measurement unit, 1Hz is one cycle per second.

Inverter mode

See “on-line” mode.

I

Current.

IEC

International Electrotechnical Commission.

IEEE

Institute of Electrical and Electronic Engineers.

Input branch circuit

The input circuit from the building power panel to the equipment.

Inverter

An electrical circuit that generates an AC voltage source from a DC voltage source.

IGBT

Insulated gate bipolar transistors.

I/O

Input/Output.

I/T or IT

Information Technology.

kVA

KiloVolt-Ampere; is equal to 1000 Volt-Ampere.

L

Line.

LCD

Liquid-Crystal Display unit.

LED

Light Emitting Diode.

Mains or Mains 1

Main AC input source.

Mains 2

Bypass AC input source.

mA

Milliampere.

MAX.

Maximum.

MCM

Thousand circular mil; standard wire sizes for multiple stranded conductors over 4/0 AWG

 

in diameter. M is from Roman numerical system indicating 1000.

N

Neutral.

NC

Normally closed.

NO

Normally open.

NEC

National Electrical Code.

NFPA

National Fire Protection Association.

G — 2

Glossary

86-86000-00 B00

Image 72
Contents EX 5/7/11RT Systems Page MGE UPS SYSTEMS, INC Scenic Avenue Costa Mesa, CA 92626 714 Technical Support Customer Care Center Hours 24/7EX 5/7/11RT Systems Contents Setup and Installation Technical Support and Product Services Return Policy for Repair of Single Phase Products RGAFigures Tables Important Safety Instructions Certification StandardsSpecial Precautions EnvironmentAdditional Modules Serial Numbers Section Descriptions This page left blank intentionally Scope Input voltage must be the same as output voltage on HV unitsPart Number Description System Electrical Characteristics Transformer Module Characteristics RatingsStandard Configuration Tower ConfigurationModel Dimensions HxWxD Weights Rack ConfigurationPower Module EX 5/7/11 RT Rear Panel ComponentsPower Module Display and Control Panel EX RT Transformer Module1 1 R T Optional Accessories Power Module Rail KitBattery/Transformer/CLA Module Rail Kit Multiple Battery Module Backup Time at Full Load Battery Extension Cable KitBattery Integration Kit with Casters Input/Output BoxEX RT Transformer Module Contents CLA Module Contents EX 5/7/11RTRecommended Batteries Unpacking and Parts Check All Modules are shipped in separate boxesContents of Standard EX 5/7/11RT Systems Contents of EXB 5/7/11RT Battery Module PN 86207 /86209 Installation in Tower Configuration Installation in Rack Mounting Configuration Not to scale Page Install input/output cables Per .7 prior to this step Bracket SystemConnecting the RS232 Communication Port Communication PortsConnecting the Dry Relay Contact Communication Port Installation of Optional Transverse CardDual U-Talk/Basic Card JBus CardProper operation Dual port Shut CardRemote Emergency Power Off Repo Communication Port System Connections Max AWG EX 11RTSources are open OFF/OPEN Always connect the earth ground wire first OutputConnecting EX RT Transformer Module Protection for all transformer output terminals120VAC output terminals Lb-N, La-N Bypass AC Mains Power Module I/O Box Connection of Battery Module EXB AC Input Connection of Optional CLA ModuleThis page left blank intentionally Initial Startup Required for initial startup onlyUPS Personalization Control Panel with scroll up and down buttonsDisplay Factory setting Options Display Factory setting Options CommentsMGE UPS SYSTEMS, INC Symptoms IT Network mode Industrial mode Then go to Advanced settings and UPS settings UPS personalization through external softwareFinal Startup sequence During the startup, if the Bypass AC source is outNormal double conversion Mode Operating ModesECO Mode ECO mode displayOperation on Battery Power Transfer to Battery PowerFirst Case Operation on battery Second Case Low battery warningPower to the load Return of Normal AC sourceShutdown Troubleshooting Symptoms Indication CorrectionBattery Fault LED Hot Swapping the Power Module 1CXXXXXXXRe-connecting the Power Module Hot Swapping the Battery Module Disconnecting the Battery ModuleRe-connecting the Battery Module This page left blank intentionally Electrical Specifications System Input/Output Power RatingsSystem Overload Characteristics Source Voltage FrequencySystem Backup Characteristics System Short Circuit ProtectionEX RT CLA Module Configuration for Hours backup time KVA / kW 25% 50% 75% 100% Output load percentageEnvironmental Characteristics Operation Mode On-line On BatteryHeat Rejection SystemMGE Standard Single Phrase Warranty Proprietary Rights StatementWarranty Extension Warranty+ not available on products User InformationProduct information Scheduling Field Service Engineer Support Part Number Assembly Number Serial numberEX 5/7/11RT Systems Glossary IEC Osha This page left blank intentionally Reorder Form Scenic Avenue Costa Mesa, CA Contact MGE