American Power Conversion MX28B200 user manual External Alarm Input Connections, No-Nc-C

Output Relay Connections

RELAY	TERMINAL
OUTPUT	DESIGNATION	USER ALARM NOTES
	NO-NC-C
	J1
RELAY #1	NO1-NC1-C1	________________________
RELAY #2	NO2-NC2-C2	________________________
RELAY #3	NO3-NC3-C3	________________________
RELAY #4	NO4-NC4-C4	________________________
	J2
RELAY #5	NO5-NC5-C5	________________________
RELAY #6	NO6-NC6-C6	________________________
MINOR	NO7-NC7-C7	________________________
MAJOR	NO8-NC8-C8	________________________

3.10. External Alarm Input Connections

Four external alarm inputs with assignable priority levels are available. These alarm inputs respond to external dry contact closures between normally open (NO) and common (C) or contact openings between normally closed (NC) and C.

External Alarm Input Definition

External Alarm Source	Connect To Input
(non-alarm state)	Alarm Terminals
OPEN	NO-C
CLOSED	NC-C

Connector J4 is located on the interface card mounted in the top left side of the unit. Refer to Figure 3.8-3for Interface board connections. Systems are shipped with jumper

wires connecting each NC and corresponding C contact. A jumper wire should be removed only if the corresponding NC-C contacts are going to be used.

External Alarm Input Connections

EXTERNAL

ALARM

INPUT

#1

#2

#3

#4

J4 TERMINAL DESIGNATION (NO-NC-C)

NO1-NC1-C1 NO2-NC2-C2 NO3-NC3-C3 NO4-NC4-C4

USER ALARM NOTES

___________________________

___________________________

___________________________

___________________________

MX28B200/400 –48 VDC User’s Manual (990-9133) Page 19