νThe PowerV ew cable must be d sconnected from the PowerV ew before proceed ng.
Wall Mounting the PowerView
Use the template below to install the PowerView on a wall:
1.Note the four mounting slots molded into the back of the PowerView.
2.Secure four large screws on a clean dry wall surface.
3.Leave each screw extending 5/16" (8mm) out from the surface of the wall.
4.Connect the 20’ PowerView remote cable (provided) to the PowerView and to the PowerView communication port at the rear of the SymmetraTM frame.
5.Position the PowerView onto the screws.
Cut Here
9cm (3 1/2")
Up
10.3cm (4")
8cm (3 1/8")
Page 10 - The PowerView Interface - Appendix A | |
|