Sanus Systems LF228 Wall Mounting, Solid concrete or concrete block, 1Mark the wall, 13 mm 10 mm

2 Wall Mounting

Solid concrete or concrete block

13 mm	10 mm
(1/2 in.)	(3/8 in.)

2-1Mark the wall

[01]

For assistance in determining wall plate location, see Height Finder at sanus.com.

Level the wall plate [01] and mark the hole locations.

CAUTION: Avoid potential injuries or property damage! ÙÙ Mount the wall plate [01] directly onto the concrete surface. ÙÙ Minimum solid concrete thickness: 8 in.

ÙÙ Minimum concrete block size: 8 x 8 x 16 in.

2-2Drill pilot holes

2-3Insert anchors and lag bolts

[26]

[26]

Drill pilot holes as illustrated.

CAUTION: Avoid potential injuries or property damage! :

ÙÙ Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.) using a 10 mm (3/8 in.) diameter drill bit.

ÙÙ Never drill into the mortar between blocks.

89mm

(3.5 in.)

Insert lag bolt anchors [26]. Then insert lag bolts [25] through the

wall plate [01] and into the anchors.

CAUTION: Avoid potential injuries or property damage! Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:

		ÙBeÙ sure the anchors [26] seat
		flush with the concrete
		surface.
		ÙÙTighten the lag bolts [25]
		only until the washers [27]
		are pulled firmly against
	[01]	the wall plate [01].
		ÙDOÙ NOT over-tighten the lag
[27]
		bolts [25].
	[25]

6901-002114 <01> 9