Runco SP-60, SP-42, SP-50 manual Seamless Switch is not available when using PIP

Operation

Seamless Switch: This feature allows for high-speed switching between any two CinemaWall inputs using the SWAP button on the remote control. To enable it, select Seamless Switch from the Option menu and set it to ON. Then, specify the two inputs you want to associate with this feature in the SELECT1 and SELECT2 fields.

By default, Input 1 and Input 2 are selected, so that when Input 1 is active, pressing

SWAP switches to Input 2 and vice versa.

Select Return to exit the Seamless Switch menu.

Seamless Switch is not available when using PIP.

Note

Picture Orient.: Select Picture Orient. to change the displayed image orientation to suit the installation method; see Figure 4-8.For example, if the CinemaWall is suspended from a ceiling, you may want to mount it upside down and run the cables upward (toward the ceiling) to make them less visible. In this case, you would select “FLIP HV.”

Normal operating state	Left-right reversal
OFF	FLIP H

Up-down, left-right reversal	Up-down reversal
FLIP HV	FLIP V

Figure 4-8. Picture Orientation

Function Reset: To restore the CinemaWall to its factory-default state, select Function Reset from the Option menu. Then, press to highlight YES and press SET. This action resets ALL settings (except the display ID Number) to their default values, as set at the factory.

This action is not undoable. Proceed with caution!

Caution

46 Runco CinemaWall SP-42/-50/-60 Owner’s Operating Manual