Panasonic WV-CU161 Preset Data Load Setting, Download Setting, Error Display

■Preset Data Load Setting

1.Display the Setup menu.

2.Select PRESET DATA LOAD by moving the joystick up or down.

3.Press the PRESET/SET/PROGRAM PRESET button.

The PRESET DATA LOAD screen appears on the moni- tor as shown below.

PRESET DATA LOAD

CAM1:

CAM2:

CAM3:

CAM4:

CAM5:

CAM6:

CAM7:

CAM8:

P : Data saved.

■: No Data saved. (CAM1 - CAM8 of the initial factory setting are marked all ■.)

(1)Download Setting

1.Display the PRESET DATA LOAD menu.

2.Select a camera number between CAM1 and CAM8 by moving the joystick up or down.

3.Press the PRESET/SET/PROGRAM PRESET button.

4.The camera number and download menu appear on the monitor as shown below.

CAM1:

DOWN LOAD

UP LOAD

DATA TITLE

5.Select DOWN LOAD by moving the joystick up or down.

6.Press the PRESET/SET/PROGRAM PRESET button. Downloading starts.

CAM1:
DOWN	LOAD	LOADING	Blinking
UP	LOAD
DATA	TITLE

END

7.While downloading, the word LOADING blinks on the right.

■ changing to P in the progress bar indicates the progress of downloading.

8.When downloading is completed, END appears on the right. The progress bar disappears.

9.Editing the DATA TITLE.

For further information, refer to (3) Data Title Setting.

Notes:

•The preset data of up to 8 cameras can be down- loaded.

•Downloading time is approx. 2 minutes per camera. When downloading is completed, the combination cam- era such as WV-CS854, WV-CS654 or WV-CS604 will move to the Preset Position.

•Any previous preset data is overwritten by the down- loaded data.

•To terminate downloading, press the HOME/ESC button while downloading. ERROR 3 appears. The progress bar disappears.

•END and error messages remain on the menu until the next operation is performed.

•In case of RS-485 Site Communication mode, check that the unit address is the same as set on the combi- nation camera. If the numbers do not agree, the camera cannot be operated.

Therefore, preset data cannot be downloaded.

•Error Display

When an error occurs during Down Loading, the follow- ing messages appear on the monitor.

Message	Cause	Note
ERROR 2	Lack of memory	Memory capacity was
		exceeded while down-
		loading.
ERROR 3	Causes except	Downloading not possi-
	above
		ble for some reason
		other than the above.

20