9.To return to the preset data menu, press the HOME/ESC button after completing the data title set- ting.
To replace a specific character
1.Use the joystick to shift the cursor to the selected char- acter area.
2.Move the cursor to the character to be replaced by moving the joystick right or left.
3.Move to shift the cursor to the character area by moving the joystick up or down, and move the cursor to the desired character by moving the joystick up, down, right or left.
4.Press PRESET/SET/PROGRAM PRESET button.
The selected character is replaced with the corrected character area.
To delete a specific character
A character is deleted by inserting a blank space.
1.Use the joystick to shift the cursor to the selected char- acter area.
2.Move the cursor to the character to be deleted by mov- ing the joystick right or left.
3.Move the cursor to the SPACE position by moving the joystick up or down.
4.Press the PRESET/SET/PROGRAM PRESET button.
[•] (space mark) appears in place of the deleted char- acter.
■Communication Setting
Note: The COMMUNICATION menu appears when the Data Switch is set to
COMMUNICATION
UNIT ADDRESS | 1 |
|
BAUD RATE | 19200 | |
DATA BIT | 8 |
|
PARITY CHECK | NONE | |
STOP BIT | 1 |
|
WAIT TIME | OFF | |
DELAY TIME | OFF | |
XON/XOFF | NOT USE |
(1) Unit Address Setting
This item lets you set a unit address that is set to the cam- era for
1.Display the COMMUNICATION menu.
2.Select UNIT ADDRESS by moving the joystick up or down.
3.Select the unit address assigned to the combination camera in the range of 1 to 96 by moving the joystick to the right or left.
The initial factory setting is 1.
Note: If the unit address is not the same, the camera can- not be operated.
(2) Baud Rate Setting
This item lets you set the baud rate for
1.Display the COMMUNICATION menu.
2.Select BAUD RATE by moving the joystick up or down.
3.Select 19200, 9600, 4800 or 2400 bps for the baud rate by moving the joystick to the right or left.
The initial factory setting is 19200 bps.
Notes:
•At a baud rate of 2400 bps, the data response may be unstable when an alarm is reset, for example.
•This setting must be compatible with the peripherals connected.
(3) Data Bit Setting
This item lets you set the number of the data bits for
1.Display the COMMUNICATION menu.
2.Select DATA BIT by moving the joystick up or down.
3.Select 7 or 8 bit for the number of data bits by moving the joystick to the right or left.
The initial factory setting is 8 bit.
Note: This setting must be compatible with the peripherals connected.
22