OPERATING PROCEDURES
CAMERA CONTROL FUNCTIONS
It is necessary to setup the camera before using the cam- era control functions. For further information, refer to the Operating Instructions for the respective combination cam- era (See page 30). You can also set it up from Camera Setup menu if you operate a system.
■Pan/Tilt Control
The following function is available with a combination cam- era or pan/tilt head.
Move the pan/tilt head in the desired direction using the joystick.
The camera can be moved in eight directions.
Joystick
ª
¶E
”
To move the pan/tilt head slowly, move the joystick while holding down the SLOW/CAMERA FUNCTION button.
Note: The SLOW/CAMERA FUNCTION button cannot be used in the camera or pan/tilt head which is not provid- ed with
■Lens Control
The following functions are available with cameras provided with controllable lens.
1.Press the FOCUS NEAR or FOCUS FAR button to adjust the lens focus while watching the monitor.
NEAR | FAR |
| FOCUS |
AUTO FOCUS | |
If you are using a camera with an auto focus feature, the lens focus can be automatically adjusted by press- ing the FOCUS NEAR and FOCUS FAR buttons simul- taneously.
2.Press the ZOOM TELE button to optically bring the object closer, or press the ZOOM WIDE button to opti- cally widen the scene.
WIDE TELE
ZOOM
IRIS
CLOSE OPEN
IRIS RESET 
Focal length differs depending on the lens installed on the camera.
3. Press the SHIFT button.
SHIFT
4.Press the ZOOM/IRIS buttons to adjust the lens focus while watching the monitor.
If the IRIS CLOSE and IRIS OPEN buttons are pressed for approx. 1 sec. or more simultaneously, the iris is reset to the default.
WIDE TELE
ZOOM
IRIS
CLOSE OPEN
IRIS RESET 
24