Nikon 2188 Depth of field, Setting the aperture, Built-in rotating tripod collar, Lens hood HK-31

Page 21

Notes on using vibration reduction

Wait until the image in the viewfinder stops vibrating before fully depressing the shutter release button after you have lightly pressed the shutter release button.

When taking panning shots, be sure to set the vibration reduction mode switch to NORMAL. If you move the camera in a wide arc when panning, vibration in the direction of that movement is not affected. For example, if you pan the camera horizontally, only vibration in the vertical direction is reduced, making smooth pans much easier.

• Due to the characteristics of the vibration reduction mechanism, the image in the viewfinder may

En

become blurred after releasing the shutter.

 

Do not turn the camera power OFF or remove the lens from the camera while the vibration reduction mode is in operation. Otherwise, the lens may emit a chattering noise if the camera is shaken. This is not a malfunction. Turn the camera power ON again to correct this.

With F80-Series/N80-Series, F75-Series/N75-Series, F65-Series/N65-Series, D100 and D70 cameras, vibration reduction does not work while the flash is recycling.

Set the vibration reduction ON/OFF ring switch to ON when the lens is mounted on a tripod. The switch should be set to ON when using a tripod without tightening the tripod head, or when using a monopod.

If you set the AF start (AF-ON) button to ON on the camera or the Focus operation button on the lens, vibration reduction will not operate.

5. Depth of field

If your camera has a depth of field preview (stop-down) button or lever, depth of field can be observed while looking through the camera viewfinder.

6. Setting the aperture

Because this lens does not have an aperture ring, you must set the aperture on the camera.

7. Built-in rotating tripod collar

When shooting vertical pictures, loosen the tripod collar lock screw by turning it counterclockwise, rotate the lens to an appropriate position, then tighten the screw clockwise.

When holding the camera by its handgrip and rotating the camera with the lens in its tripod collar, your hand may bump into the tripod, depending on the tripod in use.

Note: It’s possible to detach the tripod collar by removing the tripod collar lock screw. For details

on this procedure, contact your nearest Nikon service center or representative office.

8. Lens hood HK-31

Tighten the lens hood screw securely when using the lens hood. To store the hood, place it in the reverse position and tighten the screw securely.

21

Image 21
Contents ED200mm f/2 if 安全上のご注意 熱くなる、煙が出る、こげ臭いなどの異常時は、速やかにカメラ の電池を取り出すこと Page Page 各部の名称 はじめに ピント合わせの方法 フォーカスロック機能の使い方(図C、H) (AF-Sレンズを装着してAF使用可能なカメラのみ。P.6参照) 手ブレ補正機能(対応カメラはP.6参照) 手ブレ補正機能の概念図 被写界深度 組み込み式フィルターホルダー(図A、B) 11. ファインダースクリーンとの組み合わせ 14. 別売アクセサリー Page Nomenclature Introduction Major featuresFocusing Autofocus with manual override M/A modeTo limit the range of autofocus Using Focus preset Figs. D, H Using the Focus lock button Figs. C, HUsing AF start Figs. E, H Memory setSetting the vibration reduction ON/OFF ring switch Fig. D Vibration reduction mode See page 16 for usable camerasSetting the vibration reduction mode switch Fig. G Basic concept of vibration reductionDepth of field Setting the apertureBuilt-in rotating tripod collar Lens hood HK-31Taking flash pictures with cameras having built-in flash Slip-in filter holder Figs. A, BLens care Recommended focusing screensSupplied accessories Optional accessoriesSpecifications Page Verwendbare Kameras und verfügbare Funktionen NomenklaturFokus-Betriebstaste Eingebauter Stativanschluß FokussierschalterDie wichtigsten Merkmale EinführungAufnahmen aus einem bewegten Fahrzeug Mindestfokussierabstand von 1,9 m ist möglichAutofokus-Modus mit manueller Einstellmöglichkeit M/A-Modus FokussierenStellen Sie den Fokussierschalter Abb. E auf M/A Begrenzung des AutofokusbereichsNutzung der Fokus-Voreinstellung Abb. D, H und Fokusverriegelung Abb. C, HSpeichereinstellung SpeicheraufrufVerwendbare Kameras siehe auf Seite Vibrationsreduktions-FunktionGrundlagen der Vibrationsreduktion OFF Keine reduzierte VibrationBlendeneinstellung SchalfentiefeEingebauter Stativanschluß Gegenlichtblende HK-31Mindestfokussierabstand ist leicht verlängert Einsetzbarer Filterhalter Abb. a und BPflege des Objektivs Empfohlene EinstellscheibenZubehör SonderzubehörDe 15. Technische Daten Page Appareils utilisables et fonctions disponibles Mode de mise au point Principales caractéristiquesLorsque vous prenez des photos d’un véhicule Réglez le commutateur de mode de mise au point Fig. E à M/A Autofocus avec priorité manuelle Mode M/AMise au point Bouton de mise au point sur lobjectifRéglage mémoire Rappel mémoireUtilisation de Départ AF Fig. E, H Voir page 36 pour les appareils photo utilisables Mode réduction de la vibrationConcept de base du système de réduction de la vibration Vibration Fig. DRéglage de l’ouverture Profondeur de champCollier de trépied rotatif intégré Pare-soleil HK-31Support de filtre à insérer Fig. A, B Prise de vues avec un appareil à flash intégréFlash pourrait être retenue par la monture de l’objectif Soin de l’objectif Ecrans de mise au point recommandésAccessoires fournis Accessoires en optionCaractéristiques Page Cámaras que puede utilizar y funciones disponibles NomenclaturaPrincipales funciones IntroducciónImportante EnfoqueEnfoque automático con prioridad manual Modo M/A Para limitar el rango del enfoque automáticoAjuste de la memoria Uso de la configuración por defecto del enfoque Fig. D, HEn la memoria Recuperación de memoriaConsulte la página 46 para ver las cámaras utilizables Modo de reducción de vibraciónConcepto básico de la reducción de vibración OFF No se reduce la vibraciónAjuste de abertura Profundidad de campoCollar del trípode rotatorio integrado Notas sobre el uso de la reducción de la vibraciónVisera del objetivo HK-31 Soporte del filtro deslizable Fig. A, BEs incorporado Forma de cuidar el objetivo Pantallas de enfoque recomendadasAccesorios suministrados Accesorios opcionalesEspecificaciones Page Fotocamere utilizzabili e funzioni disponibili Caratteristiche principali IntroduzioneModalità M/A Messa a fuocoUso della preimpostazione della messa a fuoco Fig. D, H Blocco della messa a fuoco Fig. C, HImpostazione della memoria Richiamo della memoriaVedere pagina Modalità di riduzione delle vibrazioniPer le fotocamere utilizzabili, vedere a pagina Concetto di base della riduzione delle vibrazioniProfondità di campo Vibrazioni Fig. DOFF Le vibrazioni non vengono ridotte Collare girevole incorporato per il cavalletto Impostazione dell’aperturaParaluce HK-31 Portafiltro a inserimento Fig. a e B: Messa a fuoco eccellente : Messa a fuoco accettabile Schermi di messa a fuoco consigliatiAccessori opzionali Accessori in dotazioneCura e manutenzione dell’obiettivo Caratteristiche tecnicheInterfaccia CPU DimensioniInterruttore di limite di Oppure ∞ 5 m適用的相機及可用的功能 主要特色 對焦操作選擇開關(AF-L/記憶回複/AF-ON)和對焦操作按鈕 可由相機或鏡頭啟動AF-鎖功能-按下任一按鈕都可鎖定焦距 減振模式(適用相機見 66頁 ) 光圈設定 插入式濾光鏡架(圖A, B) 11. 請使用聚焦屏 Ck 尺 Page Ch *4 可使用AF-I/AF-S望遠倍率鏡TC-14E/TC-14EII/TC-17EII/TC-20E/TC-20EII。 根據對焦操作選擇開關的位置不同,對焦操作按鈕的功能也有所不同﹕ 使用預置對焦(圖D,H,I) (適用相機請見76頁。該功能在自動對焦和手動對焦時均可用。) 減振模式(適用相機見 76頁 。) 本鏡頭不帶光圈環,因此,請在機身上設定光圈。 不可用於任何拍攝距離 各種聚焦屏可通用於尼康SLR相機的任何相應的攝影場景。 下面所列可用於本鏡頭: 52mm旋入式NC濾鏡 背帶LN-1 Page Profondità di campo Depth of field13.9 10.821.7 37.3