Pioneer AVIC-N3 DIN Front/Rear-mount, DIN Front-mount, Remove the frame and the holder

DIN Front/Rear-mount

The display unit can be properly installed either from “Front” (conven- tional DIN Front-mount) or “Rear” (DIN Rear-mount installation, using threaded screw holes at the sides of the unit chassis). For details, refer to the following illustrated installation meth- ods.

Before installing the display unit

•Remove the frame and the holder.

To remove the frame, extend top and bottom of the frame outwards in order

to unlock it.

Loosen the screws (2 ⋅ 3 mm) to remove the holder. (When reattaching the frame, point the side with a groove downwards and attach it.)

•It becomes easy to remove the frame if the front panel is released.

Display unit

Holder

Screw (2 ⋅ 3 mm)

Frame

DIN Front-mount

Installation with the rubber bushing

1.Decide the position of the side brackets.

When installing in a shallow space, change the position of side brackets. In this case, stick conceal tape on parts that protrude from the dashboard.

Display unit

		English
	Conceal tape
Side bracket		Español
Flush surface screw (5 ⋅ 6 mm)
2. Install the display unit into the
dashboard.
After inserting the holder into the
dashboard, select the appropriate tabs		Deutsch
according to the thickness of the dash-
board material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
Dashboard		Français
182
53	Rubber bushing
	Screw	Italiano
Holder
Display unit
Side bracket
Screw (2 ⋅ 3 mm)		Nederlands
• After installing the display unit into

the dashboard, reattach the frame.

• If you prefer an off-set installation in which the front panel is pushed further back, when there is a space available at the back of the unit, use AD-GA10 (sold separately).

24