Pioneer AVIC-N3 installation manual After Installing this Product, Reconnecting the battery

Page 30

After Installing this Product

1.Reconnecting the battery.

First, double-check that all connections are correct and that this product is installed cor- rectly. Reassemble all vehicle components that you previously removed. Then reconnect the negative (–) cable to the negative (–) terminal of the battery.

2.Start the engine.

3.Press the RESET button on the display unit.

Press the RESET button on the display unit using a pointed object such as the tip of a pen.

4.Enter the following settings:

1.Install the program in the navigation system.

2.Drive until the initialized sensors start operating normally.

3.Set the time and language.

Set the navigation system as explained in the Operation Manual or Hardware Manual.

Note:

If you reconnected the Hide-away unit, press the RESET button.

After installing this product, be sure to check at a safe place that the vehicle is per- forming normally.

29

Image 30

Contents Installation Manual Important Information Contents Important Safeguards Connecting the System Before installing this product To prevent damageParts supplied Connecting the system Dock connectorDeutsch Français Italiano Nederlands Connecting the power cord ON/OFFGuide on Pink CAR Speed Signal Input Yellow/black Guide on When connecting to separately sold power amp NON-FADING OutputDeutsch Français When connecting a Rear view camera When connecting the external video component and the display When using a display connected to rear video outputInstallation Before installing To guard against electromagnetic interferenceInstalling the display unit and Hide-away unit Installation notesDo not cover these areas Binding screw Flush surface screw Installing the Hide-away unit Attach the side brackets to the Hide-away unitDecide on the installation position, and drill the holes Secure it firmly using the self-tapping screwsDIN Front-mount Install the display unit into DashboardDIN Front/Rear-mount Remove the frame and the holderDIN Rear-mount Fixing the front panelInstalling the GPS antenna GPS antenna Metal sheet Clamp 5 pcs When installing the antenna outside the vehicle on the body When routing the lead in from the top of the doorWhen routing the lead in from inside the trunk Start the engine Press the Reset button on the display unit After Installing this ProductReconnecting the battery Enter the following settingsEnglish Español Deutsch Français Italiano Nederlands Information Importante Sommaire Importantes Mesures DEImportantes Mesures DE Securite Branchement du système Avant de raccorder ce produit Pour éviter des dégâtsPièces fournies Branchement du système Remarque Branchement du cordon d’alimentation GaucheEnglish Français Deutsch Français Italiano Vert clair Français Rear Output English Pour relier ce produit avec une caméra de rétrovisée Pour relier l’appareil vidéo externe et l’affichage Pour utiliser un écran branché à la sortie vidéo arrièreInstallation Avant de procéder à l’installation Installation de l’unité d’affichage et de l’unité déportée Remarques sur l’installationFrançais Deutsch Français Italiano Nederlands Vis de pression Vis à tête plate Installation de l’unité déportée Fixez les supports latéraux sur l’unité déportéeChoisissez la position d’installation, et percez les trous Montage DIN avant Installez l’unité d’affichage sur Le tableau de bordMontage DIN avant/arrière Retirez le cadre et le supportMontage DIN arrière Fixation du panneau avantInstallation de l’antenne GPS Antenne GPS Plaque métallique Serre-fils 5 pièces Cheminement du câble sur le haut de la portière Cheminement du fil par l’intérieur du coffreAprès installation de ce produit Branchement de la batterieEntrez les réglages suivants Pioneer Corporation