Pioneer AVIC-N3 Installing the Hide-away unit, Attach the side brackets to the Hide-away unit

Page 23

•Install with the left and right sides of the Hide-away unit perpendicular or par- allel to your vehicle’s direction of travel. Do not install diagonally to your vehi- cle’s direction of travel or the current location will be displayed incorrectly.

Forward/Backward direction of vehicle

•Be sure to install the Hide-away unit on the floor with the silk printing side is facing up. The navigation system will operate properly only in this position.

Installing the Hide-away unit

1.Attach the side brackets to the Hide-away unit.

When the Hide-away unit is installed on the floor or the installation board under the pas- senger seat, etc., the side brackets should be attached to the unit.

English

Español

Deutsch Français

Use the following holes in the side brackets.

If the positions of the side plates are shifted in paral- lel you can also use other holes that match up with the holes in the Hide- away unit.

Hide-away unit

Washer faced screw (4 ⋅ 8 mm)

Side bracket

Italiano

Nederlands

22

Image 23

Contents Installation Manual Important Information Contents Important Safeguards Connecting the System To prevent damage Before installing this productParts supplied Dock connector Connecting the systemDeutsch Français Italiano Nederlands ON/OFF Connecting the power cordGuide on Pink CAR Speed Signal Input Yellow/black Guide on NON-FADING Output When connecting to separately sold power ampDeutsch Français When connecting a Rear view camera When using a display connected to rear video output When connecting the external video component and the displayInstallation To guard against electromagnetic interference Before installingInstallation notes Installing the display unit and Hide-away unitDo not cover these areas Binding screw Flush surface screw Attach the side brackets to the Hide-away unit Installing the Hide-away unitSecure it firmly using the self-tapping screws Decide on the installation position, and drill the holesRemove the frame and the holder Install the display unit into DashboardDIN Front/Rear-mount DIN Front-mountFixing the front panel DIN Rear-mountInstalling the GPS antenna GPS antenna Metal sheet Clamp 5 pcs When routing the lead in from inside the trunk When installing the antenna outside the vehicle on the bodyWhen routing the lead in from the top of the door Enter the following settings After Installing this ProductReconnecting the battery Start the engine Press the Reset button on the display unitEnglish Español Deutsch Français Italiano Nederlands Information Importante Importantes Mesures DE SommaireImportantes Mesures DE Securite Branchement du système Pour éviter des dégâts Avant de raccorder ce produitPièces fournies Branchement du système Remarque Gauche Branchement du cordon d’alimentationEnglish Français Deutsch Français Italiano Vert clair Français Rear Output English Pour relier ce produit avec une caméra de rétrovisée Pour utiliser un écran branché à la sortie vidéo arrière Pour relier l’appareil vidéo externe et l’affichageInstallation Avant de procéder à l’installation Remarques sur l’installation Installation de l’unité d’affichage et de l’unité déportéeFrançais Deutsch Français Italiano Nederlands Vis de pression Vis à tête plate Fixez les supports latéraux sur l’unité déportée Installation de l’unité déportéeChoisissez la position d’installation, et percez les trous Retirez le cadre et le support Installez l’unité d’affichage sur Le tableau de bordMontage DIN avant/arrière Montage DIN avantFixation du panneau avant Montage DIN arrièreInstallation de l’antenne GPS Antenne GPS Plaque métallique Serre-fils 5 pièces Cheminement du fil par l’intérieur du coffre Cheminement du câble sur le haut de la portièreEntrez les réglages suivants Après installation de ce produitBranchement de la batterie Pioneer Corporation