EN
The signal search will take approximately 10 seconds. If after 10 seconds the heart icon is not flashing, then your signal search has been unsuccessful and you need to force another signal search. See the table in the “Transmission Signal” section for more signal status information.
SETTING THE KEYPAD TONE / LIGHT MODE
You can set the watch to have the:
•Keypad “Beep” tone ON or OFF.
•Light Mode ON or OFF
(see “Activating the Backlight” section).
To set these features:
1.Press MODE to enter TIME Mode.
2.Press SET until you reach the feature you wish to change.
3.Press ST / SP / + or LAP / MEM / - to change the setting.
4.Press SET to confirm the setting and move on to the next one.
ACTIVATING THE BACKLIGHT
To activate when the Light Mode is set to OFF:
• Press 
to turn on the backlight for 3 seconds. Press any other key whilst the light is on and it will extend the light time by another 3 seconds.
To activate when the Light Mode is set to ON:
•Press any key to turn ON or extend the backlight for 3 seconds.
To help conserve power the Light Mode ON setting will automatically switch to OFF after 2 hours.
NOTE The backlight does not work when the low battery icon is shown and will return to normal once the battery is replaced.
11
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SE300_ |
| M_EN_USA.indd 11 |
|
|
|
|
| |||
|
| 8/31/06 12:13:02 PM | ||||||||