Weider WESY47330 user manual

34.Route the Butterfly Cable (67) through the Butterfly Upright (2) and over a 100mm Pulley

(38).Attach the Pulley and a Long Cable Trap

(68)to the Butterfly Upright with an M10 x 50mm Bolt (81) and an M10 Nylon Locknut (101). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley.

35.Attach the end of the Butterfly Cable (67) to the “U”-bracket (40) with an M8 Washer (100) and an M8 Nylon Locknut (87). Note: Do not complete- ly tighten the Locknut; it should be tightened so that only two threads of the Cable show past the Locknut, as shown in the inset draw- ing.

36.Identify the Lower Short Stack Cable (64). Attach the Cable to the Base (1) with an M8 x 67mm Shoulder Bolt (90), two M8 Washers (100), and an M8 Nylon Locknut (87).

37.Wrap the Lower Short Stack Cable (64) over a 100mm Pulley (38). Attach the Pulley to the Double “U”-bracket (42) with an M10 x 45mm Bolt (51) and an M10 Nylon Locknut (101).

38.Note: The following steps are shown from the back of the weight system.

Wrap the Lower Short Stack Cable (64) under a 100mm Pulley (38). Attach the Pulley and a Long Cable Trap (68) to the Base (1) with an M10 x 45mm Bolt (51). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley.

34
	38	81
	68
	101	67	2
35	67
	40			67
	100
	87			87
36		87
			100
			64
		1	100	90
37
	42
	51		101
	38		64
38
			38
			1	64
				51
			68

17