59.Attach a Seat (30) to the Sliding Seat Frame (8) with four M6 x 16mm Bolts (89). Note: The holes in the Seat are not centered; orient the Seat so that the holes are closer to the indicated end.
60.Attach the Leg Lever Lock (61) to the Leg Lever Base (5) with an M10 x 68mm Bolt (84), an M10 Washer (99), and an M10 Nylon Locknut (101).
Do not overtighten the Locknut; the Leg Lever Lock must be able to pivot easily.
61.Press two 19mm Round Inner Caps (57) into a Pad Tube (33). Insert the Pad Tube into the Butterfly Upright (2). Slide two Round Pads (34) onto the Pad Tube.
Repeat this step with the other two Pad Tubes (33), the Leg Lever Base (5), and the Leg Lever (7).
59 |
| |
Holes should |
| |
be closer to |
| |
this end |
| |
| 30 | |
| 8 | |
89 | 89 | |
60 |
| |
5 | 101 | |
| ||
| 99 | |
61 |
| |
84 |
| |
61 |
| |
33 | 34 | |
57 | ||
| ||
34 |
| |
57 |
| |
2 | 33 | |
| ||
| 7 | |
| 5 | |
| 33 |
23