Weider WESY47330 user manual 101 100 Large Ball

44.Note: The following steps are shown from the back of the weight system.

Route the Leg Press Cable (65) under a 100mm Pulley (38). Attach the Pulley and a Long Cable Trap (68) to the Leg Press Base (3) with an M10 x 92mm Bolt (55), an M10 Washer (99), and an M10 Nylon Locknut (101). Make sure the Cable

Trap is oriented to hold the Cable in the groove of the Pulley.

45.Wap the Leg Press Cable (65) around a 90mm Pulley (39). Attach the Pulley and a Short Cable Trap (48) to the M10 x 121mm Carriage Bolt (49) in the Base (1) with an M10 Nylon Locknut (101).

Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley.

46.Wap the Leg Press Cable (65) under a 90mm Pulley (39). Attach the Pulley and a Short Cable Trap (48) to the Base (1) with an M10 x 50mm Bolt (81) and an M10 Nylon Locknut (101). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley.

47.Attach the end of the Leg Press Cable (65) to the “U”-bracket (40) with an M8 Washer (100) and an M8 Nylon Locknut (87). Note: Do not complete- ly tighten the Locknut; it should be tightened so that only two threads of the Cable show past the Locknut, as shown in the inset draw- ing.

48.Identify the Ab Cable (66). Route the Cable under a 100mm Pulley (38) and through the Leg Lever (7) and the Leg Lever Base (5). Attach the Pulley inside the Leg Lever with an M10 x 65mm Bolt (80), two M10 Washers (99), two 12.5mm Spacers (69), and an M10 Nylon Locknut (101).

Make sure the large ball on the Cable is in the position shown.

44		3
			101
			99
				38
			68	65
		55
45
			101
				48
				39
				65
		49	1
46			101
			65
	1			81
		39	48
47
87
100
				87
40
65				65
48		7
5				101
			99
		69
				38
99				66
80
69				Large
				Ball

19