49. Route the Ab Cable (66) through the Butterfly | 49 |
|
| |
Upright (2). Attach a 100mm Pulley (38) inside |
|
| ||
|
|
| ||
the Leg Lever Base (5) with an M10 x 65mm Bolt |
|
|
| |
(80), two M10 Washers (99), two 12.5mm |
| 5 |
| |
Spacers (69), and an M10 Nylon Locknut (101). |
| 38 |
| |
|
|
| ||
| 66 |
| 101 | |
|
| 99 | ||
| 2 |
| 69 | |
|
| 69 |
| |
|
| 99 |
| |
|
| 80 |
| |
50. Note: This step is shown from the back of the | 50 |
|
| |
weight system. |
|
| ||
|
|
| ||
Lay the Ab Cable (66) in the indicated brackets. |
|
|
| |
Attach a 100mm Pulley (38) inside the bracket on |
|
|
| |
the Base (1) with an M10 x 45mm Bolt (51) and |
|
| 51 | |
an M10 Nylon Locknut (101). | Brackets |
| ||
|
| |||
|
|
| 38 | |
|
| 1 |
| |
|
| 101 | 66 | |
|
|
| ||
51. Wrap the Ab Cable (66) over a 100mm Pulley | 51 |
|
| |
(38). Attach the Pulley and a Long Cable Trap |
|
| ||
|
|
| ||
(68) to the second set of holes from the bottom of |
|
|
| |
the two Pulley Plates (41) with an M10 x 50mm |
| 41 |
| |
Bolt (81) and an M10 Nylon Locknut (101). Make |
| 2 | ||
|
| |||
sure the Cable Trap is oriented to hold the |
|
| ||
| 101 | |||
Cable in the groove of the Pulley. Make sure |
| |||
the Cable is routed over the Pulley toward the |
|
| 68 | |
front of the Butterfly Upright (2). |
| 81 | ||
|
| |||
|
| 38 |
| |
|
| 66 |
| |
52. Note: The following steps are shown from the | 52 |
|
| |
back of the weight system. | 81 | 66 | ||
| ||||
Wrap the Ab Cable (66) under a 100mm Pulley |
| 38 |
| |
(38). Attach the Pulley and a Long Cable Trap |
|
| ||
(68) to the Butterfly Upright (2) with an M10 x |
|
|
| |
50mm Bolt (81) and an M10 Nylon Locknut (101). |
|
|
| |
Make sure the Cable Trap is oriented to hold |
|
|
| |
the Cable in the groove of the Pulley. |
| 68 |
| |
|
|
| ||
|
| 2 |
| |
|
| 101 |
| |
| 20 |
|
| |